Overview
The Artec Industries high steer ARP studs and nuts kit is a set of four studs with tapered nuts for high steer arms on a 60 kingpin axle. It fits steering arms that are 1 in. to 1.5 in. thick, so measure your arm before ordering.
Artec Industries supplies aftermarket parts for off-road enthusiasts. The kit has a 220,000 psi tensile strength rating, fine thread on both ends, and tapered nuts.
Key features
- Fine thread on both ends
- Tapered nuts
- 220,000 psi tensile strength
- Fits steering arms 1 in. to 1.5 in. thick
- Set of 4 studs and nuts
Before you install
High steer arms carry steering load from the tie rod to the knuckle, so the studs and nuts that hold them are worth checking before any trail season. A stud that fits loosely or has damaged threads can let the arm shift under load, which shows up as wander, play or a clunk at the wheel. Measure the arm thickness and inspect the stud holes before you start, since a poor fit is easier to catch on the bench than on the trail.
When choosing a kit, look at how the nuts seat against the arm. Tapered nuts rely on a clean, matching taper, so remove corrosion or paint from the arm face first. Plan to replace all four studs together, not one at a time, so the load is shared evenly across the set.
- Inspect the kingpin bushings and tie rod ends at the same time
- Use a torque wrench and recheck the nuts after the first few drives
- Keep threads clean and lightly oiled before assembly
Specifications
| Brand | Artec Industries |
|---|---|
| UPC | 816791023131 |
| Set quantity | 4 studs and nuts |
| Arm thickness | 1 in. to 1.5 in. |
| Axle | 60 kingpin |
| Tensile strength | 220,000 psi |
| Thread | Fine, both ends |
| Nut type | Tapered |
Vehicle fitment
Artec gives a universal fit designation, but the kit is sized for a specific arm thickness and a 60 kingpin axle rather than any one vehicle. Measure the steering arm and confirm the axle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that each arm falls within the 1 in. to 1.5 in. thickness range before fitting the studs. Steering components carry heavy loads, so have the installation checked by a qualified installer.
What’s included
Included: a set of four studs and tapered nuts.









