Overview
The Artec Industries TR8801 is a Ford 8.8 swap kit with a truss top, built for 2004–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon models and 1997–2006 Jeep Wrangler (TJ) models. It is a rear axle kit built around a 1/4 in. thick mild steel truss.
The truss top has the link brackets built in. The kit includes upper and lower control arm mounts, shock mounts, sway bar mounts, track bar mount and coil spring mounts, which fall into place once the truss is tacked together on the axle.
Key features
- Reinforced truss top of 1/4 in. thick mild steel
- Link brackets built into the truss
- Brackets for control arms, shocks, sway bar, track bar and coil springs
- Ford 8.8 axle with 31 spline shafts and a trac-loc differential
- The 8.8 in. ring gear is 120% stronger than the Dana 35.
Gears, brakes and track width
Changing to a Ford 8.8 changes more than the axle housing. The gear ratio, the axle width and the brake setup all have to be checked together. A new ratio helps the axle match tire size and engine output, and the setup should be verified after the gears are set. The narrower track width affects how the tires sit in the fenders, so measure clearance before choosing wheel spacers.
Brake work is one of the larger tasks in this kind of swap. Relocated brake lines need support clear of heat and moving parts, and the disc brake setup should be bled and tested before the vehicle is driven off the lift. Inspect the lines and fittings after the first few trips, since routing changes can cause chafing.
- Check gear ratio against tire size
- Measure fender clearance before spacers
- Bleed and test brakes before driving
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | TR8801 |
| UPC | 816791024749 |
| Axle type | Ford 8.8 |
| Axle location | Rear |
| Steering ram mount | Not included (listed without) |
| Axle tube diameter | 3-1/4 in., compared with 2.625 in. on the Dana 35 |
| Ring gear | 8.8 in. |
| Brakes | Disc brakes on 1995 and newer axles |
| Axle spline | 31 |
| Weight | The 8.8 is about 20 pounds heavier than a Dana 35. |
| Track width | 1.25 in. narrower than the Dana 35 |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon, and the 1997–2006 Jeep Wrangler (TJ) in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
The Ford 8.8 uses the same lug nut bolt pattern as the Dana 35, and it has disc brakes from 1995 onward, which affects the brake work the swap involves.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires welding and general fabrication. Some grinding and fitment work may be needed, since every axle varies slightly.
Brake lines will need to be relocated to fit the 8.8.
The 8.8 is 1.25 in. narrower than the Dana 35, so wheel spacers may be needed to bring the width back to factory specification.
The 3.73 gear ratio may need to change to match the gears in your Jeep.
What’s included
The truss kit with brackets for the control arms, shocks, sway bar, track bar and coil springs.
Not included: A steering ram mount, which the kit is listed without.






































