Overview
The 4882350 is a rear passenger side axle shaft for the Dana 44, with 30 splines. It fits 1997–2002 Jeep Wrangler (TJ) models in SE, Sahara, Sport and X trim.
The shaft is the rear right unit with passenger side location, and the bullets give the Dana 44 axle type.
Key features
- Rear passenger side shaft
- Dana 44 axle type
- 30 splines
Choosing a replacement shaft
A Dana 44 shaft carries more load than the lighter axles used on earlier Jeeps, so the spline fit and hub connection matter more here. A worn spline can slip under torque and cause a clunk on acceleration, which is a sign the shaft should be checked before it fails on the trail.
Buying a shaft is often paired with new axle seals, a fresh gasket set and inspection of the wheel bearings, because the axle is already disassembled. If the axle housing shows oil on the brake backing plate, address that source first so the new shaft does not run in leaking fluid.
- Inspect splines for rounding or twist
- Replace the axle seal during the job
- Check the wheel bearing and hub nut torque
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4882350 |
| Axle maker | Dana |
| Axle location | Rear |
| Axle shaft location | Passenger side |
| Position | Rear right |
| Axle type | Dana 44 |
| Axle spline | 30 splines |
Vehicle fitment
It fits 1997–2002 Jeep Wrangler (TJ) in SE, Sahara, Sport and X trims.
The bullets give the Dana 44 axle type and 30 splines.
Compare the 30 splines and Dana 44 axle type with the shaft being replaced before fitting, and confirm the axle on your vehicle matches before ordering.
The list covers 1997–2002 only, so 2003 and later TJ years are not on it.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear passenger side axle shaft.









