Overview
The Artec Industries SP1402 is a pair of high misalignment spacers for one rod end, identified as 7/8 inch in the product name.
The bore is 3/4 inch, while the size is 7/8 inch. Measure the rod end bore before assembly and confirm which size suits your joint. It is a universal fit, so the spacer is not tied to a particular vehicle.
Key features
- Two high misalignment spacers included for one rod end
- 7/8 inch size
- Bore given in the specifications as 3/4 inch
- Universal Fit, Artec part number SP1402
Spacers and joint alignment
A misalignment spacer sits between the rod end and its mount, letting the joint line up straight so the threads do not carry an angled load. The spacer should seat fully on both faces without forcing the rod end out of square. Because the bore must match the pin, measure the rod end before assembly and check the spacer against it. A spacer that is too tight can bind the ball and wear it, while one that is loose can work out under vibration.
When replacing spacers, inspect the old ones for flattened edges, cracks or rust, and compare their length and thickness to the new set. Tighten the retaining hardware to the value your build calls for and check the joint through its full arc afterward. Record the setup so future adjustments return to the same alignment.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | SP1402 |
| UPC | 816791023346 |
| Included | 2 misalignment spacers |
| Size (per title) | 7/8 inch |
| Bore (per specifications) | 3/4 inch |
| Fitment | Universal Fit |
Vehicle fitment
Artec gives Universal Fit for this spacer, so it is not matched to a specific make, year or model.
No vehicle years or chassis codes are stated. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The title and bore figures differ, so measure the rod end bore before assembly and confirm the spacer size matches it.
What’s included
Two high misalignment spacers for one rod end.
Not included: the rod end the spacers are used with.









