Overview
The Artec Industries SP1203 is a pair of wide high misalignment spacers made from 303 stainless steel, intended for heim joints with a 3/4 inch bore installed in a bracket that is 2.625 inches wide.
The 2.625 inch bracket width is common in many stock parts. These spacers let a builder keep 2.625 inch brackets when moving to a larger joint, instead of cutting off the brackets and welding new ones. A single wide spacer also avoids the multiple shear points that stacked spacer sets create.
Key features
- Wide high misalignment spacers for heim joints
- For any heim with a 3/4 inch bore
- Suits locations with a 2.625 inch bracket width
- Keeps existing 2.625 inch brackets if you move to a larger joint later
- Made from 303 stainless steel
- Supplied in pairs
Choosing spacers for a joint upgrade
Spacers are most useful when a joint has to be upgraded but the bracket stays. Misalignment spacers fill the gap between a larger bore and a smaller bracket, so the joint can sit square without modifying the bracket itself. Clean the bracket and spacer faces before assembly, and check that the spacer is fully seated so the load passes through the spacer and not the fasteners alone.
Because spacers sit inside a load path, they should be matched to the joint carefully. Look for uneven wear on the joint after use and replace any spacer that shows galling or cracking. In steering or suspension links, a professional installation and an alignment check afterward are a sensible step.
- Confirm the bore before ordering
- Clean bracket and spacer faces
- Inspect for galling after use
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | SP1203 (also shown as A/ISP1203) |
| UPC | 816791023285 |
| Product type | High misalignment heim joint spacers |
| Width style | Wide |
| Heim bore size | 3/4 inch |
| Spacer bore | 9/16 inches |
| Bracket width | 2.625 inches |
| Material | 303 stainless steel |
| Quantity | Offered in pairs |
| Fitment type | Universal fit |
Vehicle fitment
The SP1203 is a universal fit part. Compatibility depends on the joint and bracket rather than a vehicle: the heim must have a 3/4 inch bore and the bracket width must be 2.625 inches.
Check the joint bore and bracket width before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Torque all fasteners to the values that suit your joint and bracket, and confirm the stack-up before final tightening.
- Check the part against your vehicle before starting work.
- Re-check fasteners after the first miles of driving, and again after hard off-road use.
- Check the stack-up of joint, spacers and bracket before final tightening so the joint is not pinched or loose.
- If the spacers are used in suspension or steering links, have the work done by a professional and check the alignment afterward.
What’s included
One pair of spacers.
Not included: Heim joints, bolts and brackets are not included.









