Overview
The Artec RE2001 is a 1.25 inch rod end kit, also called a heim joint, for suspension and steering links that need a pivoting connection. It is a universal fit kit and is not built for one vehicle. The kit includes a jam nut, a wrench flat tube adapter and two stainless steel spacers.
The rod end body is heat and cryogenically treated 4130 Chromoly, and the 1-1/4 inch thread shank runs right hand. Cryogenic treatment increases the strength of the steel body and the density of the nylon race.
Key features
- Chromoly rod end with a 1.0 inch bore and 1-1/4 inch -12 thread shank
- Right hand thread direction
- Heat and cryogenically treated 4130 Chromoly body with a polished chrome finish
- Ball made from heat treated bearing steel with a hard chrome polished surface
- Teflon impregnated nylon race, which Artec says keeps the joint quiet and tight
- Two stainless steel 3/4-1.0 inch high misalignment spacers included
Checking the link before install
Heim joints carry load in a link, so the joint has to suit the link and its mounting points. Measure the mounting hole and the width the joint must fill, then match the shank and bore to the tube or bracket. Thread engagement matters: the shank should run far enough into the tube or sleeve that the threads are fully supported, and the jam nut should seat firmly against the housing.
Rod ends are sensitive to angle. Check that the joint has room to pivot through its full travel without contacting the link, boot or nearby components. Use lubricant only if the joint is designed for it, and recheck the jam nut after the first drives since vibration can loosen it.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | RE2001 |
| UPC | 816791022943 |
| Kit size | 1.25 inch rod end |
| Shank | 1-1/4 inch, -12 threads per inch, right hand thread |
| Bore | 5/8 inch |
| Rod end bore | 1.0 inch |
| Body material | Heat and cryogenically treated 4130 Chromoly |
| Ball | Heat treated bearing steel, hard chrome polished |
| Race | Teflon impregnated nylon, injection molded |
| Finish | Polished chrome |
| Mounting width | 2.625 inch with spacer |
| Mounting hole | 3/4 inch |
| Spacers | Two stainless steel, 3/4-1.0 inch high misalignment |
| Fitment | Universal fit |
Vehicle fitment
It is a universal fit kit, not built for a named vehicle. The 2.625 inch mounting width with the spacer and the 3/4 inch mounting hole decide whether it suits a given link.
Measure the link and mounting points for your application against these figures before fitting the kit.
Installation notes
The wrench flat tube adapter is sized for 1.5 inch ID to 2.0 inch OD tubing, so it applies when the rod end is installed in tubing of that size. Rod ends carry load in steering and suspension links, so check thread engagement and jam nut tightness after installation.
What’s included
- One 1.25 inch Chromoly rod end with 1.0 inch bore
- One jam nut
- One wrench flat tube adapter for 1.5 inch ID to 2.0 inch OD tubing
- Two stainless steel 3/4-1.0 inch high misalignment spacers









