Overview
The ARB Shackle and Pin Kit OMEGS2 is a front shackle and pin kit for the Toyota Land Cruiser (Base) in the 1960–2011 and 2013–2014 model years. It uses a greasable, bolt-together assembly designed to prevent out-of-angle shackle pin to side plate problems.
The pins carry two grease outlet holes apiece, which ARB describes as giving maximum grease coverage. The kit is offered under the ARB 4×4 Accessories brand with part number OMEGS2.
Key features
- Front position shackle and pin set for the Land Cruiser Base
- Easy bolt-together assembly
- Two grease outlet holes per shackle pin
- Greasable pins for ongoing lubrication
- Direct fit per the manufacturer fitment list
Setting up the front shackles
The front shackle and pin set controls how the spring eye moves as the suspension compresses and rebounds. When the pin sits square in the side plate, the spring moves in a controlled arc and the bushings wear more evenly. A pin that sits out of angle places side load on the bore and can cause clunks over washboard roads.
Setup starts with checking the bolts and washers in the order your installation calls for, then confirming the pin is fully seated before the final tightening. After the first few drives, recheck the fasteners, since new hardware can settle. Keep the grease flowing through each pin, especially after water or mud, and replace any pin that shows scoring or a worn bore.
- Check pin seating before final tightening
- Recheck fasteners after the first drives
- Grease pins after water and mud exposure
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | OMEGS2 |
| UPC | 881348005991 |
| Position | Front |
| Type | Shackle and pin kit |
| Lubrication | Greasable, two grease outlets per pin |
| Fitment type | Direct fit |
Vehicle fitment
The manufacturer fitment list covers the Toyota Land Cruiser (Base) from 1960 through 2011, and again for 2013 and 2014. The list has a gap between 2011 and 2013.
Land Cruiser trims beyond the Base entry are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the assembly bolts together, check that the pin seats square in the side plate before final tightening. Grease each pin through its outlet holes after assembly. Support the front axle securely while working on the shackles.
What’s included
The kit is a front shackle and pin set with greasable pins. Look over the parts on hand before starting the kit.






