Overview
The ARB Shackle Hanger Bracket OMEGP8 is a rear shackle hanger for the 1968–1980 Toyota Land Cruiser Base. A hanger carries the shackle at the frame end of the leaf spring.
The bracket is designed to replace factory hanger units.
Key features
- Rear position
- Designed to replace factory hanger units
- Greasable.
- Direct fit for listed 1968–1980 Toyota Land Cruiser Base
Signs the hanger needs replacing
The hanger holds the shackle at the frame end of the spring, so any movement at that point shows up in steering feel and ride. Over time the hanger can crack around the welds, the bolt holes can elongate and the bushings can flatten. Each of these changes lets the spring end shift, which affects how the axle tracks under load.
Inspect the hanger when the rear shackles are greased and after hard trail use. Lift the vehicle safely, then check for play in the shackle and any gap between the hanger and frame. When replacing a hanger, take the load off the spring first, clean the mounting surfaces, and set new fasteners to the correct torque. Re-check the fittings after the first few drives.
- Play at the shackle or hanger
- Cracks near welds or mounts
- Elongated or worn bolt holes
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | OMEGP8 |
| UPC | 881348005939 |
| Type | Shackle hanger bracket |
| Position | Rear |
| Feature | Greasable |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1968–1980 Toyota Land Cruiser in the Base trim.
Other Land Cruiser trims and years outside 1968–1980 are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a hanger means supporting the vehicle and spring before removing the old unit. Check shackle movement after fitting, and do not drive the vehicle until the spring is properly supported.
What’s included
Confirm the included bolts and bushings against your installation before starting.
Not included: the shackle and pin parts may need to be fitted separately.






