Overview
The Rugged Ridge 7/8-inch D-ring isolator, part number 11235.43, is a molded polyurethane cover for D-ring shackles. Its job is to keep the shackle body and pin from knocking against your bumper, which reduces the loud clang many off-road owners hear on rough terrain.
Molded from energy-absorbing polyurethane, the isolator snaps over the outer perimeter of the shackle. The urethane washers sit between the shackle pin and the mounting tab, isolating that contact point as well. Rugged Ridge makes the design for both 3/4-inch and 7/8-inch shackles and offers several colors, including Pink.
Key features
- Energy-absorbing polyurethane body that cushions shackle contact
- Snap-on design that wraps the outer perimeter of the shackle
- Urethane washers separate the pin from the mounting tab
- Offered in Black, Red, Green, Yellow and Pink
- Aimed at reducing shackle noise during off-road recovery and trail use
Care and inspection
Isolators take a lot of abuse from grit, mud and repeated contact with metal, so check them each time the shackle comes off the vehicle. Look for cuts, flat spots or places where the polyurethane has pulled away from the edge. A worn isolator stops cushioning, and the shackle body can start to ring against the bumper again.
Urethane washers need the same attention. If they have flattened, cracked or slipped out of position, the pin can contact the mounting tab directly. Rinse the set after muddy runs, let it dry fully, and keep a spare set of washers for the next recovery.
- Replace isolators that show cuts or torn edges
- Confirm the washers still sit between the pin and the tab
- Clear grit from the pin before reinstalling the shackle
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11235.43 |
| UPC | 804314290863 |
| Product type | D-ring isolator |
| Shackle size | 7/8-inch |
| Material | Energy-absorbing polyurethane |
| Included | 2 isolators and 4 urethane washers |
| Colors | Black, Red, Green, Yellow, Pink |
| Fitment | Universal fit |
Vehicle fitment
The part is universal fit and is not tied to a particular vehicle or model year. Compatibility is set by the shackle, which should be a 7/8-inch D-ring for this part number.
Rugged Ridge also makes the same design for 3/4-inch shackles, so check the pin diameter before fitting.
Installation notes
Work each isolator over the shackle body, then seat the urethane washers between the pin and the mounting tab. The isolator guards surfaces against contact but does not raise the working load limit of the shackle.
What’s included
The package holds 2 isolators and 4 urethane washers.
Not included: The D-ring shackle itself and any mounting hardware.


















