Overview
The Rugged Ridge 11235.41 is a 7/8-inch D-ring isolator pair made to keep recovery shackles from knocking against a bumper. Molded polyurethane covers snap over the shackle, so the outer body is shielded wherever it could touch nearby metal. This is a universal accessory, so it is chosen by shackle size rather than by vehicle.
The pair also includes urethane washers, which Rugged Ridge places between the shackle pin and the mounting tab. Together the cover and washer are meant to stop the rattle that shackles produce when they swing on the bumper. Color options named by the manufacturer are Black, Red, Green, Yellow and Pink.
Key features
- Molded from energy-absorbing polyurethane
- Snaps over the shackle’s outer perimeter
- Urethane washers separate the pin from the mounting tab
- Covers all portions of the shackle that could contact the bumper
- Color options: Black, Red, Green, Yellow and Pink
Protecting bumpers and mounts
Shackles that swing against a bumper wear paint, scratch powder coating and can ring like a bell over rough ground. Covers and washers reduce that contact so the shackle sits quietly in its mount. Inspect the cover after each use for cuts, flattened sections or chips, since a damaged isolator stops protecting the metal it was meant to shield.
Pick isolators by shackle body diameter and check the pin and tab clearances before installing. Polyurethane stiffens in very cold weather, so a snug fit in summer may feel loose later in the year. Keep spare washers on hand, because they wear faster than the covers. Wipe off mud and grit, and avoid storing the isolators with oil or fuel residue, which can soften the material over time.
- Check covers for cuts after rough trails
- Replace worn urethane washers
- Keep the pin fully seated before recovery
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11235.41 |
| UPC | 804314290849 |
| Shackle size | 7/8-inch |
| Material | Energy-absorbing polyurethane |
| Pack contents | 2 isolators, 4 urethane washers |
Vehicle fitment
Universal fit: this isolator is not vehicle-specific and works with any D-ring shackle of the 7/8-inch size. Measure the shackle body before buying a pair so the cover slides on without force.
The product family also includes a 3/4-inch size, which is a different part.
Installation notes
Place each isolator over the shackle body and set the washers between the pin and the mounting tab. Confirm the pin is fully seated before the shackle takes any load.
What’s included
Two isolators and four urethane washers in each pair.
Not included: the D-ring shackle itself.


























