Overview
The Rugged Ridge 11235.42 is a set of D-ring isolators for 7/8-inch recovery shackles. The polyurethane shells wrap the outer edge of the shackle so metal does not strike the bumper when the rig bounces. It is a universal fit part, since it attaches to the shackle rather than the vehicle.
Rugged Ridge includes urethane washers that isolate the shackle pin from the mounting tab, giving the company’s stated full coverage at that contact point. The isolators are molded in a range of colors, including Black, Red, Green, Yellow and Pink, so you can match a paint scheme.
Key features
- Energy-absorbing polyurethane shell that snaps over the shackle
- Urethane washers placed between the shackle pin and the mounting tab
- Covers the shackle’s outer perimeter to limit contact with nearby surfaces
- Molded colors: Black, Red, Green, Yellow and Pink
Fit and check before a recovery
A recovery shackle carries a load that is much greater than the noise it makes on the drive. Before attaching a strap, confirm the isolator sits fully over the shackle body and that the pin is seated home. A partly seated shell can slide or pinch, which defeats its purpose and leaves the metal exposed at the bumper.
Keep the isolators with the rest of the recovery kit so they are ready to fit. Look for cracks, flat spots and grit in the opening after each trail run. Because the washers sit between the pin and the mounting tab, check that they are still intact there, and replace any worn pieces before the next pull.
- Check pin seating before each recovery
- Replace cracked or flattened washers
- Rinse mud from the shell after trail runs
- Store the set out of direct sun when not in use
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11235.42 |
| UPC | 804314290856 |
| Shackle size | 7/8 inch |
| Material | Energy-absorbing polyurethane with urethane washers |
| Pack contents | 2 isolators, 4 washers |
Vehicle fitment
Universal fit, so no vehicle list applies. The isolator is sized to a 7/8-inch D-ring shackle, and it is not a bumper or mounting part. Make sure your shackle matches that diameter before you fit it.
If your shackle is 3/4 inch, look for the smaller-size isolator in the same line.
Installation notes
Work each isolator over the shackle, then position the washers where the pin meets the mounting tab. Make sure the pin sits fully home before the shackle carries weight.
What’s included
Two isolators and four washers per pair.
Not included: D-ring shackles.




















