Overview
The Rugged Ridge 11235.31 is a D-ring isolator for 3/4 inch recovery shackles. Its energy-absorbing polyurethane body snaps over the outer edge of the shackle so metal does not clang against the bumper, mounting tab or other nearby surfaces on the trail. It is a universal fit part, so the shackle diameter decides whether it works.
The same design is made for 7/8 inch shackles. Urethane washers included in the set sit between the shackle pin and the mounting tab, so the contact points are covered on both sides of the shackle. The color range runs from Black and Red to Green, Yellow and Pink.
Key features
- Energy-absorbing polyurethane body that snaps over the outer perimeter of the shackle
- Urethane washers isolate the shackle pin from the mounting tab
- Designed to virtually eliminate the noise of d-ring shackles striking nearby surfaces
- Fits 3/4 inch shackles; the line also covers 7/8 inch shackles
- Molded in several colors, including Black, Red, Green, Yellow and Pink
- Packed as 2 isolators and 4 washers
Choosing the right shackle size
Matching the isolator to the shackle is the step that decides whether it works. The shell has to fit the body closely enough to stay in place on the trail, so measure the shackle diameter before ordering. A loose fit can slip off during a bounce, and an oversized shell can leave the metal exposed where it meets the bumper. Shackle sizes differ across recovery gear, so check the markings or the pin rather than guessing.
Replacement is part of ownership. Polyurethane can harden in heat, crack in cold or tear after contact with rocks, and any of those changes reduces contact coverage. Inspect the isolators and washers after each trip. Swap the set when the shell loses its grip or the washers no longer sit squarely between the pin and the mounting tab.
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11235.31 |
| UPC | 804314290795 |
| Material | Energy-absorbing polyurethane isolators with urethane washers |
| Shackle size | 3/4 inch |
| Included | 2 isolators and 4 urethane washers |
| Colors in line | Black, Red, Green, Yellow, Pink |
| Fitment | Universal fit |
Vehicle fitment
It is a universal fit part, so it is not tied to a specific vehicle year, model or trim. Choose it by shackle diameter, and use this isolator on 3/4 inch shackles.
Measure your shackle before ordering, because the 7/8 inch size is a different fit.
Installation notes
Snap the polyurethane body over the shackle, then set a urethane washer on each side of the mounting tab at the pin. Confirm the isolator fully covers the shackle where it meets the bumper before using it in a recovery.
What’s included
Two isolators and four urethane washers.
Not included: the recovery shackle itself.


























