Overview
The Rugged Ridge 3/4-inch D-Ring Isolator (part number RUG11235.32) is a molded urethane isolator that keeps recovery shackles from banging against the bumper. It is made of energy-absorbing polyurethane and snaps over the outside of the shackle.
The set covers every portion of the shackle that could contact the bumper. Urethane washers add isolation at the pin and tab area. The isolators are offered for 3/4 and 7/8 inch shackles in several colors.
Key features
- Energy-absorbing molded polyurethane
- Snaps over the outer perimeter of the shackle
- Covers all portions of recovery shackles that could contact the bumper
- Urethane washers isolate the shackle pin
- Available in several colors
- Universal fit
Before the first recovery
The first time a sleeve goes on a shackle, take a few minutes to seat it properly. Work it over the bow until it stops moving, then check that the washers sit flat on the tab. A loose fit at this stage often causes the scuffing that owners blame on the isolator, so it pays to correct it before the rig heads onto the trail.
Recovery gear also needs a look after each use. Pull the shackle, check the sleeve and washers, and make sure nothing has been pinched or torn. If you swap shackles between vehicles, keep each pin with its own bow, since a mismatched pin can sit crooked and defeat the isolator. Store spare sleeves away from heat and sun, which dry out the material over time.
- Seat the sleeve fully before the first trip
- Check washers for pinch marks after each recovery
- Keep pins paired with their own shackle bows
- Store spare sleeves away from direct sun
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | RUG11235.32 |
| UPC | 804314290801 |
| Material | Energy-absorbing polyurethane |
| Shackle size | 3/4-inch (line also offered for 7/8-inch) |
| Colors offered | Black, Red, Green, Yellow, Pink |
| Included | 2 isolators and 4 urethane washers |
Vehicle fitment
This is a universal recovery accessory under Rugged Ridge’s Universal Fit listing. It is not built for a specific vehicle, so choose it by shackle size rather than by make or model.
Choose the isolator by shackle size. Confirm the shackle diameter is 3/4 inch before ordering.
Installation notes
Set the urethane washers between the shackle pin and the mounting tab first. Then snap the isolator over the outer perimeter of the shackle so the metal stays away from the bumper.
What’s included
2 isolators and 4 urethane washers.




















