Overview
The Pro Comp 50095 is a rear U-bolt packaged with hi-nuts and extra thick washers. Confirm its profile, size and finish against your axle and spring before fitting.
Key features
- Rear U-bolt
- Hi-nuts included
- Extra thick washers included
Rear clamp installation
A rear U-bolt clamps the axle to a rear leaf spring or spring pad, which is where most of the vertical movement happens. Before installing, check that the U-bolt legs line up with the plate holes and that the bend sits squarely against the axle tube.
Hi-nuts are taller than standard nuts, giving more thread engagement on the legs. Extra thick washers spread the clamp load over the plate, which helps when the spring seat is soft or worn. Tighten the nuts evenly in a cross pattern, then recheck them after the first drives.
Inspect the threads and bend at each service interval and replace any U-bolt with cracks, kinks or stretched threads. Worn spring seats and shackles can also make a rear clamp loosen, so check them while the U-bolt is out.
- Lift the vehicle safely before removing the old U-bolts
- Clean rust from the axle seat and plate before reassembly
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 50095 |
| UPC | 614901234787 |
| Position | Rear |
| Hardware | Hi-nuts, extra thick washers |
Vehicle fitment
Verify the rear fit by matching your vehicle’s year, model and trim before buying. Measure the axle and spring to confirm this rear U-bolt suits the setup.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The rear U-bolt with hi-nuts and extra thick washers, part number 50095.







