Overview
The Omix-ADA 18204.10 is a long nut for the U-bolts used on classic Jeep and Willys models. It is sold as a single nut, and two are required for each U-bolt. It is a direct OE replacement built to original specifications, and it carries a limited five year warranty.
The list covers Jeep CJ3, CJ5, CJ6, DJ3, DJ5, DJ6, Dispatcher, Gladiator, Jeepster, Panel and the FC, J-series and Wagoneer models, along with Willys CJ-2, CJ-3, CJ-5, CJ-6, DJ-3, Jeepster and 1-ton models from the late 1940s and 1950s.
Key features
- Long nut for U-bolts
- Two required for each U-bolt.
- Direct OE replacement
- Built to original specifications
- Limited five year warranty
Before you install
A U-bolt clamps the axle to the leaf spring, and the long nut threads onto each end of the U-bolt to hold that clamp in place. The nut carries the full clamping load, so its threads have to match the U-bolt exactly. Cross-threaded or corroded threads can strip under load and let the axle shift on the spring.
When U-bolts are replaced, it is worth replacing the nuts at the same time, especially on an older vehicle where the threads have seen years of road salt and moisture. Clean the threads before fitting, then tighten the nuts evenly in a crisscross pattern so the axle seats squarely against the spring pad.
- Inspect threads for rust, flat spots or stretching
- Replace nuts together with U-bolts when both are worn
- Tighten evenly in a crisscross pattern
- Re-check the nuts after the first few drives
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | OAI18204.10 |
| Type | U-bolt long nut |
| Quantity | Sold as single; two required for each U-bolt. |
| Warranty | Limited five year warranty |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1959–1971 Jeep CJ3, CJ5, CJ6, DJ3, DJ5, DJ6, Dispatcher, Gladiator, FC, J-series and Wagoneer (SJ) models, the 1957–1958 Jeep F4 and FC models, the 1941–1958 Willys models, and the Jeepster and Panel models from the 1940s through 1971, in the trims covered.
The list covers the older Jeep and Willys vehicles. Models from the 1972 and later Jeep line are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Two long nuts are required for each U-bolt. Check the nut and bolt for thread match before the axle is secured.










