Overview
The Trail Master nitrogen gas twin tube shock absorber (part number TM73215008) is a rear shock for the 1997–2006 Jeep Wrangler (TJ) and the 2004–2006 Jeep Wrangler (LJ) Unlimited. It is designed for a 1.5 to 2 inch suspension lift.
The shock uses nitrogen stabilization and 10-stage velocity sensitive valving. The piston rod is 5/8 inch and chrome hardened, and an optional shock boot is available as a separate part.
The TJ and LJ applications share this rear shock. The LJ fits the Unlimited and Unlimited Rubicon trims, and the TJ fits the trims shown in the vehicle fitment section. The 1.5 to 2 inch lift range is the sizing point, and a higher lift calls for a different Trail Master part.
Key features
- Rear position for TJ and LJ Wranglers
- Twin tube nitrogen stabilized design
- 10-stage velocity sensitive valving
- 5/8 inch chrome hardened piston rod
- Designed for a 1.5 to 2 inch lift
- Nitrogen gas charge
Rear shock service basics
The rear shock controls axle movement and helps the rear tires stay in contact with the ground on rough trails. On TJ and LJ models, the rear shocks work with the leaf springs and axle to manage the weight carried in the back. Good damping keeps the rear end settled after a bump rather than bouncing for several cycles.
Lift height affects shock length and the angle the shock works through. A 1.5 to 2 inch lift falls within the sizing range for this shock, and a larger lift needs a shock designed for it. Check the travel of the rear axle at full extension and compression before installing, so the shock does not bottom out or bind.
Replace rear shocks in pairs when possible so both sides respond alike. Inspect the eyes, bushings and boots at each service and look for leaking oil or a rod with pits. A boot helps keep grit off the rod; it is an optional part here, so decide before the install whether you want one for trail use.
- Check eye bushings for wear
- Watch for oil on the shock body
- Inspect the rod for pitting or scoring
Specifications
| Brand | Trail Master |
|---|---|
| Part number | TM73215008 |
| Shock series | Nitrogen gas twin tube |
| Location | Rear |
| Shock type | Twin tube, nitrogen stabilized |
| Valving | 10-stage velocity sensitive |
| Piston rod | 5/8 inch chrome hardened |
| Lift range | 1.5 to 2 in |
| Shock boot | Optional, separate part |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler (LJ) in the Unlimited and Unlimited Rubicon trims, and the 1997–2006 Jeep Wrangler (TJ) in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
The list does not include the front position, the YJ or JK Wrangler, or any Cherokee. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This rear shock is designed for a 1.5 to 2 inch lift, so check the lift height on your TJ or LJ before ordering. The shock boot is an optional separate part, so plan for it before the install if you want one.
What’s included
One rear nitrogen stabilized twin tube shock. Not included: the optional shock boot.











