Overview
The Trail Gear 186028-KIT is a rod end kit with a 3/4 Inches – 16 left hand shank and a 5/8 Inches bore. Trail Gear marks it Universal Fit, which means no single vehicle is named; confirm the thread and bore against your current tie rod first.
Its body is 4340 Chromoly with zinc coating, and the ball is AISI 52100 steel that is hard chrome-plated. The kit comes with a Teflon liner and a jam nut.
Key features
- 4340 Chromoly body with zinc coating
- AISI 52100 ball, hard chrome plating
- Teflon liner
- Left hand thread direction
- Jam nut included
Tie rod work basics
Replacing a tie rod end is one of the more common steering jobs, and it is often done as part of a wider inspection. Before removing the old end, mark its position on the tie rod so that toe settings can be restored close to where they were. Count turns, or measure the thread length, so the new end starts at about the same position.
Thread engagement matters. The rod should be threaded into the tube or sleeve far enough to carry load, and the jam nut should be tightened against the sleeve. Look at the boot and the sleeve clamp too, because worn parts beside the new end can loosen it or let dirt into the ball.
- Mark the original position before removing the end
- Check that the jam nut is fully seated
- Inspect boots and clamps alongside the new end
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 186028-KIT |
| UPC | 70000621300 |
| Shank | 3/4 Inches – 16 |
| Bore | 5/8 Inches |
| Thread direction | Left Hand |
| Body material | 4340 Chromoly, zinc coated |
| Ball material | AISI 52100, hard chrome-plated |
| Liner | Teflon |
| Fitment | Universal Fit |
Vehicle fitment
Trail Gear gives Universal Fit only, with no vehicle, year or model named. Check the 3/4 Inches – 16 thread and 5/8 Inches bore against the tie rod you are replacing before you fit it.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the thread is left hand, check that the existing linkage turns the same way before threading the new rod end on.
What’s included
The kit comes with the jam nut and the rod end body described above.









