Overview
The Trail Gear 130586-1-KIT is a right hand rod end for heavy duty tie rod steering, with a 1 inch bore. It is intended for FJ-80 and Toyota crossover steering applications.
The rod end is greased for life and sealed. The kit includes a cotter pin and jam nut.
Key features
- Right hand thread
- Greased for life and sealed
- Includes cotter pin and jam nut
- Heavy duty construction
- 1 inch bore
Steering rod end care
A tie rod end is a ball joint that takes the push and pull of steering and passes it to the wheel. Sealed, greased-for-life joints avoid routine grease fittings, but they still wear, so the boot, the joint’s movement and the stud fit should be checked whenever the steering is serviced. Heavy duty ends are often chosen for rough trail use, where impacts and articulation put more strain on the joint.
Setting toe is part of installation. Set the length with the rod end at the correct position, tighten the jam nut only after toe is set, and recheck the setting after the first drives. Look for play at the stud, a torn boot or stiff movement, which signal that the joint is worn and needs replacement.
- Check the boot for tears before each trail season
- Feel for play at the stud with the wheel off the ground
- Recheck toe after the first few drives
- Replace the cotter pin rather than reusing a bent one
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 130586-1-KIT |
| UPC | 70000621500 |
| Bore | 1 inch |
| Shank | N/A |
| Thread direction | Right hand |
| Lubrication | Greased for life |
| Sealing | Sealed |
| Included | Cotter pin, jam nut |
Vehicle fitment
It suits FJ-80 and Toyota crossover steering applications. Verify the year, model and trim against your vehicle before buying.
Compare the bore and thread direction with your existing rod end. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the right hand thread and 1 inch bore to the rod end you are replacing. The jam nut locks the setting, so tighten it after the toe is adjusted.
What’s included
Rod end, cotter pin and jam nut.









