Overview
The Trail Gear 120002-1-KIT is a 67 in. bare steel rock slider kit for Toyota rocker panel protection. Each slider is a tubular guard that takes rock strikes on the lower body, keeping the sheet metal beside the cab intact on rough trails. It is sold as a pair and needs welding for installation.
The sliders are built from 1 3/4 in. OD by .120 wall 1035 DOM tubing. Trail Gear says DOM steel resists splitting better than the cheaper HREW tubing some rivals use, and that the sliders can carry the full weight of the truck. A high-lift jack can be positioned anywhere along the slider to reposition the rig or lift it for repairs.
Key features
- Tubular guard with tubular standoff
- 1035 DOM tubing rather than HREW
- Six loose mounting legs, three per side
- Legs pre-notched on one side for trimming on the other
- 11 1/4 in. legs allow the slider to be used as a step
- Unpainted, lightly oiled bare steel
Choosing mounts and legs
Rock sliders absorb strikes that would otherwise reach the cab-side sheet metal, so their job is mostly protective. The tubing takes the scrapes, and the steel legs carry the load when the truck leans onto a rock. Choosing the right leg position matters, because a slider set too high misses the rock and one set too low can catch brush.
Using a jack on a slider puts load into the welds and mounts, so place the jack on a flat, solid section and keep the lift controlled. Trim only the unnotched leg side when the fit needs it, and grind cut edges smooth before painting to avoid snagging clothes or gloves.
- Look for cracked welds after hard trail days
- Check leg bolts and clamps before each trip
- Keep a welder and spare grinding discs on hand
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 120002-1-KIT |
| UPC | 70000621342 |
| Length | 67 in. |
| Tubing | 1 3/4 in. OD x .120 wall 1035 DOM |
| Finish | Unpainted bare steel, lightly oiled |
| Mounting legs | Six, three per side, 11 1/4 in. long |
| Installation type | Welding required |
| Sold as | Pair |
Vehicle fitment
The kit is built for Toyota rocker panels. The 58 in. version uses the same six-leg layout, while the 78 in. version uses eight.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan on welding the mounts, since the legs are supplied loose and are not attached at the factory. Position the legs for your frame before making any welds, and trim the unnotched side only as needed. Eye protection and welding gloves are necessary while cutting and welding this steel.
What’s included
A pair of 67 in. rock sliders with six loose mounting legs, three per side.
Not included: Welding equipment, plus any frame plates or extra hardware needed to attach the sliders.









