Overview
The Poison Spyder DIY Slider Tube Kit, bare steel, part number DIY-08-030, is a do-it-yourself kit for a rugged DOM tube slider. Its main tubes measure 53.75 inches, and it fits the 1981 to 1985 Jeep Scrambler and the 2004 to 2006 Jeep Wrangler LJ. The kit adds a slider to Poison Spyder Rocker Knockers or other plate steel rocker armor, and welding is required.
The kit contains the slider tubes and the short tube supports that brace the middle of the tube against the rocker, for both sides of the Jeep. The tubes are CNC bent and pre-notched to mount at an angle, the same way the ready-built Rocker Knockers with Sliders are set up.
Key features
- Main tubes measure 53.75 inches long
- Kit includes slider tubes and short tube supports
- Covers both sides of the Jeep
- Slider tubes CNC bent and pre-notched to mount at an angle
- DOM tubing for the slider
- Welding required
Choosing a slider setup
A slider works best when it is matched to the armor it bolts to. Plate steel rocker armor gives the tube a solid surface to weld against, and the supports spread the load so the middle of the tube does not flex during a hard obstacle hit. The rocker height and the body’s lower edge set how far the tube sits from the side of the Jeep, which is why the test fit matters.
Plan the build before striking an arc. Clamp the tubes in place, check the angle at both ends, and confirm the slider clears the tires at full steering lock. Keep the welds clean and let each joint cool before stressing it. After the first trail runs, look over the ends and supports for hairline cracks or loose parts, and address any issue promptly.
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | DIY-08-030 |
| UPC | 614901732412 |
| Type | Tubular guard, DIY kit |
| Finish | Bare steel |
| Main tube length | 53.75 inch |
| Components | Slider tubes and short tube supports |
| Installation | Welding required |
Vehicle fitment
It fits the 1981 to 1985 Jeep Scrambler and the 2004 to 2006 Jeep Wrangler LJ, and it is designed for the LJ and the CJ-8. Confirm your Jeep is one of these models before welding.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, so this kit is for a builder who can weld the slider tubes in place. Test-fit the tubes against the rocker first, and check the angle of each pre-notched tube before welding.
What’s included
Slider tubes for both sides, short tube supports and bare steel tubing ready to weld.









