Overview
The Smittybilt SRC Rocker Guard (part 76641) is an E-coated textured black rocker guard made from heavy-duty 2 inch steel tubing. It is built to take on rough terrain, and Smittybilt offers two styles so the guard can match the look and needs of the build.
Installation requires drilling, and the guard may not work with some shackle reversion suspensions. Check your suspension type before ordering.
Key features
- E-coated textured black finish
- Heavy-duty 2 inch steel tubing
- Tubular guard with standoff
- Two styles available
- Drilling required
Choosing the right standoff setup
The standoff is the part of a tubular rocker guard that sets its distance from the body, and that distance matters on a Jeep with a shackle reversion setup. Suspension geometry changes how the frame and axle move, so a guard that clears at rest can contact the body or hardware at full articulation. Measure the gap at both ends of the guard before you commit to drilling.
Drilled mounts are permanent, so plan the layout first. Mark the hole positions with the guard held in place, check for fuel lines, wiring and brake lines behind the body panel, and confirm the standoff sits flat before you start. Once holes are drilled, clean the edges, deburr them, and apply primer to any bare metal.
After installation, check the mounts after the first few trail runs and again after any hard impact. Loosening bolts, a cracked weld at the standoff or chipped coating at the mounting points are early signs the guard needs attention. A guard that moves on its mounts can rub paint off the body and wear the hardware faster.
- Check suspension clearance at full articulation
- Plan hole locations before drilling
- Prime bare metal at each drilled hole
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 76641 |
| UPC | 631410079715 |
| Tube size | 2 inch steel tubing |
| Finish | E-coated textured black powder coat |
| Style | Tubular guard with standoff |
| Installation | Cutting or drilling required |
| Suspension note | May not work with some shackle reversion suspensions |
Vehicle fitment
It is a direct fit guard. Check your suspension type alongside your year and model before buying.
Installation notes
Drilling is required, so test-fit the guard and mark the holes before cutting or drilling. Check the standoff clearance against your suspension before final tightening.
What’s included
One SRC rocker guard with its tubular standoff.


















