Overview
The Trail Gear 120001-1-KIT is a 58 in. long pair of bare steel rock sliders for Toyota rocker panels. Rock sliders guard the lower body beside the doors, so rocks and ledges meet steel tubing instead of sheet metal. The kit is sold as a pair, ships unpainted, and requires welding during installation.
Trail Gear makes these from 1 3/4 in. OD by .120 wall 1035 DOM tubing. The company says its testing supports DOM over the HREW tubing used by many competitors, which it reports can split down the seam under heavy stress. The slider is designed to carry the weight of the truck, so a high-lift jack can be placed along it to reposition the vehicle on the trail or lift it for repairs.
Key features
- Tubular guard with tubular standoff design
- 1 3/4 in. OD x .120 wall 1035 DOM tubing rather than HREW
- Mounting legs ship loose, so they can be set in different positions
- Legs are pre-notched on one side and can be trimmed on the other
- Legs are 11 1/4 in. long, letting the slider stick out far enough to use as a step
- Bare steel with no paint, lightly oiled to slow rust
- Sold as a pair
Before you weld
A rock slider sits between the wheels and takes the hits that would otherwise dent the lower body. On a trail it also gives a solid edge to drive over, which helps when a tire climbs a ledge. Steel tubing handles repeated contact well, but welds and mounts see the most stress, so they deserve attention before each trip.
Welded installation means the frame and body mounts have to be right the first time. Set the legs for your frame, tack them in place, and check the slider height and angle against the rocker before finishing the welds. Bare steel rusts quickly once paint is gone, so prime and paint welds and cut edges soon after fitting.
- Check welds for cracks after the first few trail runs
- Re-tighten bolted mounts after the first trips
- Touch up bare steel with paint or rust inhibitor
- Keep the sliders clear of the frame crossmember when articulating
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 120001-1-KIT |
| UPC | 70000621387 |
| Length | 58 in. |
| Tubing | 1 3/4 in. OD x .120 wall 1035 DOM |
| Finish | Unpainted bare steel, lightly oiled to prevent rust |
| Mounting legs | Six, three per side, 11 1/4 in. long, pre-notched on one side |
| Installation type | Welding required |
| Sold as | Pair |
Vehicle fitment
The kit is built for Toyota rocker panels. The 78 in. version uses eight mounting legs, while the 58 in. and 67 in. versions use six.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, so this kit suits a fabrication shop or a builder comfortable welding frame and body mounts. Set the legs in the position that suits your frame, and trim the unnotched side only if needed. Wear eye protection and welding gloves while cutting and welding the steel.
What’s included
A pair of 58 in. rock sliders with six mounting legs, three per side. The legs are loose, not welded on.
Not included: Welding equipment and the hardware needed to attach the sliders to your vehicle.









