Overview
The Trail Gear Rock Defense Jeep front bumper in bare steel, part number 303141-2-KIT, is a stubby-width, bolt-on bumper made from 1/4 inch steel for the 1987-2006 Jeep Wrangler YJ and TJ. It is brake-formed for a precise fit and needs no welding for installation.
The integrated winch plate is pre-drilled for most 5000-10000 model low-profile winches, and its fairlead mount works with a hawse or a roller fairlead. Two heavy-duty removable D-ring recovery points are part of the design. The kit includes the fairlead mount, extended winch mount hardware and black grade 8 mounting hardware, and the bumper arrives in bare steel.
Key features
- 1/4 inch bare steel, brake-formed for a precision fit
- Fully bolt-on design with zero welding required
- Integrated winch plate pre-drilled for most 5000-10000 model low-profile winches
- Fairlead mount works with a hawse or roller fairlead
- Two removable D-ring recovery points
- Fairlead mount and extended winch mount hardware included
- Black grade 8 mounting hardware included
Winch and fairlead setup
A front bumper is only as useful as the recovery gear it carries. When adding a winch, check that the winch’s mounting bolts seat fully against the plate and that the cable path runs straight from the fairlead to the load without rubbing the bumper or the hood. Pulling at an angle puts side load on the fairlead and the bumper corners, so use a snatch block or a tree saver where the setup calls for it, and keep recovery straps and shackles rated for the load.
Bare steel needs attention once it is on the vehicle. Dirt, moisture and road salt collect around bolt holes and welds, so clean and inspect the bumper after each trip where it meets the frame. Re-check every bolt after the first drives and again after heavy winching, since repeated loads can loosen hardware. Keep the D-ring points free of corrosion so they can be used with confidence when needed.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 303141-2-KIT |
| UPC | 700007372611 |
| Product type | Front bumper, Rock Defense |
| Position | Front |
| Width | Stubby |
| Material | Steel, 1/4 inch |
| Finish | Bare |
| Winch compatibility | Most 5000-10000 model low-profile winches |
| Fairlead | Hawse or roller |
| D-ring mounts | Two removable recovery points, included |
| Winch mount | Included |
| Light mounts | Not included |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list for 303141-2-KIT covers the 1998-2006 Jeep Wrangler (TJ) and the 1987-1995 Wrangler (YJ).
The fitment covers the 1998-2006 Wrangler TJ and the 1987-1995 Wrangler YJ. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The bumper is fully bolt-on and needs no welding. The kit includes black grade 8 hardware and extended winch mount hardware. Bare steel should be finished before it is exposed to weather.
What’s included
- Rock Defense front bumper in bare steel
- Two removable D-ring recovery points
- Fairlead mount and extended winch mount hardware
- Black grade 8 mounting hardware
Not included: the winch, fairlead and lights.














