Overview
The Trail Gear Rock Assault front bumper in bare steel, part number 120176-1-KIT, is a full-width, bolt-on winch bumper for the 1995-2004 Toyota Tacoma. It is the first of several Tacoma bumpers in Trail Gear’s line and is built from 1020 DOM tubing, 1.75 inch by .120 wall.
It is a true bolt-on product that needs no cutting or welding. The winch plate is drilled for most 5000-9500 model low-profile winches and smaller 9.0R winches, and a shackle receiver gives you an anchor point for winch or strap recoveries. The finish is unpainted steel.
Key features
- Fits the 1995 to 2004 Tacoma
- 1020 DOM tubing, 1.75 inch by .120 wall
- True bolt-on; no cutting or welding required
- Winch plate drilled for most 5000-9500 model low-profile winches
- Shackle receiver for winch or strap recoveries
- Unpainted steel finish
- Hawse type fairlead required
Choosing a winch setup
A winch mounted behind a front bumper puts load on the bumper, the frame mounts and the bolts that hold everything together, so the setup should be checked before each season of off-road use. Match the winch to the plate and confirm the cable exits cleanly through the fairlead opening. A hawse type fairlead guides the cable at a fixed angle, which keeps the winch line from rubbing against the plate. Larger winches sometimes need small grille adjustments, so test fit the assembly before final tightening.
Recovery straps and shackles put heavy shock loads through the receiver, so use rated shackles and inspect pins and threads regularly. Look for elongated bolt holes, cracks at the welds and loose hardware after hard use. Shackle receivers wear differently from winch plates, so treat them as separate inspection points. Keep the winch cable and rope in good condition, and replace frayed sections before they fail under load.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 120176-1-KIT |
| UPC | 70000621239 |
| Product type | Front bumper, Rock Assault |
| Position | Front |
| Width | Full |
| Material | Steel, 1020 DOM tubing 1.75 inch by .120 wall |
| Finish | Bare, unpainted steel |
| Winch compatibility | Most 5000-9500 model low-profile winches; smaller 9.0R winches |
| Fairlead | Hawse type only |
| Winch mount | Included |
| D-ring mounts | Not included |
| Light mounts | Not included |
| Towing | Not rated for towing |
| Fit type | Direct fit |
Vehicle fitment
It fits Toyota Tacomas from 1995 through 2004.
The 2005 and newer Tacoma is a different generation and has its own Trail Gear bumpers; it is not covered by this part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Trail Gear says no cutting or welding is required. The bumper needs a hawse type fairlead rather than a roller, is not intended for use with a body lift, and does not come with turn signal and license plate mounting tabs. Larger winches may need minor grille trimming.
What’s included
- Rock Assault front bumper in unpainted steel
- Winch plate
- Shackle receiver
Not included: the winch, fairlead, D-ring mounts, light mounts, and turn signal and license plate mounting tabs.












