Overview
The Trail Gear Rock Assault Nine knuckle, part number 300540-KIT, is sold as a pair of steering knuckles for use with the Rock Assault Nine or a Dana 60 axle.
Universal Fit is also stated, but that wording sits beside axle-specific use, so confirm the axle type before fitting.
Before fitting knuckles
The steering knuckle carries the wheel hub and bearing and pivots on the upper and lower ball joints, so it turns the wheel when the steering moves. When a knuckle is replaced, the hub, brake backing plate and ball joint connections all have to be checked against the new part. Old bushings and bearings are often replaced at the same time to avoid a second teardown.
Knuckle swaps change steering geometry, so an alignment check is needed afterward. Inspect the tie rod ends, drag link and any wear in the axle joints before installation, because a loose part there can make a new knuckle feel imprecise. Clean the hub mating surfaces and check bolt condition before torquing to the values in a service manual.
- Ball joint and tie rod end wear
- Wheel bearing and hub condition
- Brake line and caliper clearance
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 300540-KIT |
| UPC | 700007698291 |
| Quantity | Pair |
| Intended use | Rock Assault Nine or Dana 60 axle |
Vehicle fitment
This knuckle set is intended for the Rock Assault Nine or Dana 60 axle. Confirm the axle type on your vehicle before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Knuckle work changes steering geometry, so a shop should verify alignment and steering after the job.
What’s included
Confirm what arrives with the pair, including any hardware and bearings, before installing.









