Overview
The Trail Gear 140054-1 is a factory Toyota knuckle stud, supplied on its own. It fits 1979-1985 Toyota front solid axle knuckles and the 1990-1997 Toyota FJ80 Landcruiser.
Because this is a stud only, the nut, washer and tapered cone are not part of the package. Confirm the years and axle setup for your vehicle before ordering.
Key features
- Factory Toyota knuckle hardware
- Knuckle stud only
- Fits 1979-1985 Toyota front solid axle knuckles
- Fits 1990-1997 Toyota FJ80 Landcruiser
Fitting a knuckle stud
A knuckle stud carries load at the knuckle and must seat square to avoid premature wear or loosening under load. Before fitting, clean the bore and check the threads for damage, since a damaged thread can strip under torque. Use fresh hardware whenever the stud is removed, and compare the stud with the knuckle it will enter so the length and taper are right for the axle setup.
Because the nut, washer and tapered cone are not part of this stud, gather them before the job starts. Tighten to the value your service procedure calls for, and recheck torque after the first drive. Older Toyota front axles often have worn knuckle bores, so inspect the surrounding parts for play and replace worn ones as needed.
- Check the knuckle bore for wear
- Use the correct nut and cone
- Recheck torque after the first drive
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140054-1 |
| UPC | 70000621585 |
| Type | Knuckle stud (single stud) |
| Included | Stud only |
| Not included | Nut, washer, tapered cone |
| Application years | 1979-1985 Toyota front solid axle knuckle; 1990-1997 Toyota FJ80 Landcruiser |
| Fitment type | Direct Fit |
Vehicle fitment
Two Toyota applications are covered: 1979-1985 front solid axle knuckles and the 1990-1997 FJ80 Landcruiser. Confirm the exact axle setup against your vehicle before ordering.
Other Toyota years and models are not covered by these years. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Keep a nut, washer and tapered cone on hand when fitting the stud, since none come with it.
What’s included
Knuckle stud only.
Not included: Nut, washer and tapered cone.









