Overview
The Crown Automotive 52067577 is a left, driver-side steering knuckle for Jeep Cherokee (XJ), Grand Cherokee (ZJ) and Wrangler (YJ, TJ and LJ) models. It is a stock replacement knuckle that is not built for high steer or cross over steering setups.
Crown Automotive offers over 8,000 different part numbers for Jeep vehicles, and this knuckle is one of them. It is a direct fit replacement for the driver side of the models in the fitment section below.
Key features
- Left, driver-side position
- Direct fit stock replacement design
- Not high steer compatible
- Not cross over steering compatible
- Covers Cherokee XJ, Grand Cherokee ZJ and Wrangler YJ, TJ and LJ models
Stock knuckle role
The steering knuckle holds the hub, the wheel bearing and the steering arm, so it carries both steering and wheel loads. On stock Jeep front axles, the knuckle works with the ball joints and tie rod to turn the wheel as the driver steers. Its position matters, because a knuckle for the wrong side will not line up with the hub or steering arm.
A stock replacement knuckle keeps the factory geometry, which is why high steer or cross over setups need their own parts. When replacing a knuckle, check the ball joints, bearings and seals on the same corner and inspect the steering arm for bends. Play at the hub, uneven tire wear or a steering wheel that pulls can signal a worn knuckle or related joint.
- Confirm the side matches the hub and arm
- Inspect ball joints and bearings on the same corner
- Recheck alignment after the job
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52067577 |
| UPC | 848399015225 |
| Position | Left (driver side) |
| Replacement type | Stock replacement |
| High steer compatible | No |
| Cross over steering compatible | No |
| Fitment type | Direct fit |
Vehicle fitment
It fits the following models and trims:
- 1990 and 1992–2000 Jeep Cherokee (XJ): Base, Briarwood, Classic, Country, Laredo, Limited, Pioneer, SE, Sport
- 1993–1998 Jeep Grand Cherokee (ZJ): 5.9 Limited, Base, Laredo, Limited, Orvis, SE, TSi
- 2004–2006 Jeep Wrangler (LJ): Unlimited, Unlimited Rubicon
- 1997–2006 Jeep Wrangler (TJ): 65th Anniversary Edition, Rubicon, SE, Sahara, Sport, X
- 1990–1995 Jeep Wrangler (YJ): Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara
Wrangler JK and JL models, Liberty and Grand Cherokee WJ are not on this list, and neither are years outside the ranges above. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because this knuckle is not high steer compatible, do not use it on a high steer setup. Check your steering arm and drag link configuration before installing it.
What’s included
One driver-side steering knuckle. Check the package contents against your installation, including any hardware or bearings, before starting.












