Overview
The TeraFlex 4828490 is a Dana 30 high steer knuckle for the passenger side of a Jeep front axle. It replaces the outer knuckle with a one-piece high steer knuckle that raises the steering arm position to correct steering linkage geometry on vehicles with five or more inches of lift.
The knuckle is built for lifted rigs that need custom steering. Tapered inserts let the drag link enter from the top or the bottom of the steering arm. The tapered sleeves accept either stock taper rod ends or the large taper rod ends used on standard Dana 60 axles. It works with leaf spring suspensions (YJ) or custom link suspensions such as the Tera LCG system.
Key features
- Dana 30 passenger-side high steer knuckle that replaces the outer knuckle
- Raises the steering arm position to correct steering linkage geometry at five or more inches of lift
- Tapered inserts allow the drag link to enter from the top or the bottom of the steering arm
- Tapered sleeves fit stock taper rod ends or large taper rod ends used on standard Dana 60 axles
- One-piece knuckle design
- Works with leaf spring suspensions (YJ) or custom link suspensions such as the Tera LCG system
- Modified replacement type
Choosing custom steering parts
A high steer knuckle moves the steering arm up so the drag link runs closer to level with the track bar. That geometry matters most on a lifted vehicle, where the stock arm angle can cause bump steer and binding. Before buying, measure your lift height and confirm the axle and passenger side match the knuckle.
Because the knuckle changes the steering linkage, the tie rod and drag link have to be matched to it. Taper sizes, rod end threads and the steering arm mounting style all affect what will fit. Plan the linkage before the knuckle goes in, and expect the steering to be checked and aligned afterward.
- Match tie rod ends to the taper on the steering arm
- Inspect the upper and lower ball joints during the swap
- Check drag link clearance through the full steering range
- Use new hardware wherever the old fasteners show wear
- Confirm brake and hub parts work with the new knuckle
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 4828490 |
| UPC | 843885026143 |
| Axle | Dana 30 |
| Position | Passenger side |
| Knuckle type | High steer, one-piece outer knuckle |
| Lift height | Five or more inches of lift |
| Replacement type | Modified replacement |
Vehicle fitment
The manufacturer fitment list for this TeraFlex knuckle includes the following vehicles:
- 1997 and 2000–2001 Jeep Cherokee (XJ), Classic, Country, Limited, SE and Sport trims
- 2004–2006 Jeep Wrangler (LJ), Unlimited and Unlimited Rubicon trims
- 1997–2006 Jeep Wrangler (TJ), 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims
Wrangler JK, Wrangler JL and Grand Cherokee models are not covered, and neither are YJ and ZJ models. Compare your year, model and trim with the fit above before ordering.
Installation notes
Custom tie rod and drag link are required and are sold separately from TeraFlex. For Wranglers and Cherokees older than 1991, the front calipers, rotors and uni-bearings must be replaced with those from 1992–2006 Wranglers and Cherokee XJs. The stock OEM ends will not work in place of the TeraFlex stock-taper 1-ton end. Because this knuckle changes steering geometry, have the steering setup checked by a qualified installer after fitting.
What’s included
One TeraFlex Dana 30 high steer knuckle for the passenger side.
Not included: custom tie rod and drag link, which are available separately from TeraFlex.












