Overview
The Trail Gear 130251-1-KIT is a Rock-Assault hydraulic ram steering assist kit for 1979-1995 Toyota Pickups and 4Runners with a solid front axle. The Toyota kit has a 6″ x 1.5″ stroke hydraulic ram with high temperature inner and outer seals.
The ram is built with high temperature seals. Compared with kits that leave out mounts or supply only generic tabs, this kit includes brackets shaped for the Toyota axle and High Steer. The 3/4 inch rod is 50% stronger than the 1/2 inch rods used on other kits, and the brackets are formed from heavy-duty 1/4 inch plate steel. For Dana knuckle applications, an 8 inch stroke version is available.
Key features
- 6″ x 1.5″ stroke hydraulic ram
- High temperature inner and outer seals
- 3/4″ rod, which Trail Gear says is 50% stronger than a 1/2″ rod
- Brackets formed from 1/4″ plate steel
- Mounting hardware shaped for the Toyota axle and High Steer
Steering assist and seal care
A hydraulic ram on a solid axle takes the force that a steering box would otherwise carry alone, so the ram, rod and mounts all see repeated load on the trail. Seals are the part most likely to show wear, because dirt that reaches the rod can score the seal lip and let fluid escape.
Care is simple. Keep the rod clean, check for fluid seepage after each trip, and watch for scoring on the rod surface. A damaged rod should be addressed quickly, since it can wear new seals fast. Before any major trip, confirm the brackets and ram ends are tight and free of cracks.
- Wipe the ram rod clean after muddy runs.
- Check for fluid seepage around the seals.
- Inspect brackets and ram ends for cracks.
- Keep spare seals on hand for remote trips.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 130251-1-KIT |
| Ram stroke | 6″ x 1.5″ |
| Rod diameter | 3/4″ |
| Bracket material | 1/4″ plate steel |
| Axle | Solid front axle |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1979-1995 Toyota Pickup and 4Runner with a solid front axle, and it is a direct fit for the 1985-1995 Toyota 4Runner and 1979-1995 Toyota Pickup.
Trucks with independent front suspension are not covered, and Dana knuckle applications need the separate 8″ stroke version. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The steering box must be tapped before the ram is installed. Installation of the ram takes about one hour after that.
What’s included
- 6″ x 1.5″ stroke hydraulic ram
- Mounting brackets









