Overview
The Advance Adapters TJ transfer case shifter bracket is a shifter linkage bracket for the 1997 to 2006 Jeep Wrangler TJ, including Rubicon and Unlimited models. It is designed to eliminate the body mount used in the factory TJ shifter linkage, so the bell crank can stay in alignment.
In the factory setup, the shifter bell crank pivots between a transfer case mounting bracket and a body mount. When the transfer case moves during a transmission retrofit or when a flat skid plate is used, the transfer case shifter mounting bracket moves with it and misaligns the bell crank. Body lifts cause the same misalignment, so this bracket addresses both situations.
Key features
- Eliminates the body mount in the TJ transfer case shifter linkage
- Keeps the shifter bell crank aligned after a transmission retrofit or flat skid plate
- Also addresses misalignment caused by body lifts
- Designed for NP231, NV241 and NV241OR transfer cases
- It requires no welding or cutting when used with the factory TJ skid plate.
Linkage alignment after a lift
A shifter linkage works through a series of pivots, so a change in the transfer case position or a body lift moves the geometry. The bell crank has to stay in line with the transfer case shifter for smooth shifts. A bracket that removes one of the body mount points changes how the linkage moves under load, so the alignment is worth rechecking.
Before driving, check that the shifter moves freely through each position and that the bell crank does not bind at the end of travel. Recheck after the first few drives, because bushings and fasteners may settle. If a body lift is fitted, measure the shifter position relative to the transfer case again.
- Move the shifter through every position by hand
- Check the bell crank for binding
- Recheck fasteners after the first drives
Specifications
| Brand | Advance Adapters |
|---|---|
| UPC | 808331012491 |
| Transfer case models | NP231, NV241, NV241OR |
| Part type | Transfer case shifter linkage bracket |
| Welding or cutting | None required with the factory TJ skid plate (per brand) |
Vehicle fitment
It fits 1997 to 2006 Jeep Wrangler TJ models, including Rubicon and Unlimited versions.
It is designed for the 1997 to 2006 Wrangler TJ with NP231, NV241 and NV241OR transfer cases. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Because the bracket replaces the body mount, the linkage geometry changes once it is fitted. Check that the shifter bell crank lines up with the transfer case shifter before driving. Support the vehicle on stands before working underneath it.
What’s included
The kit contents are best confirmed before you start. Check the included hardware against the installation steps first.









