Overview
The TeraFlex 1457400 is a 4 inch Elite LCG long arm lift for the Jeep Wrangler JK. It balances a low center of gravity with ground clearance, and its handling gains are similar to the 6 inch long arm system. The kit fits tires up to 37 inches and needs aftermarket wheels with 4.5 inch backspacing or less.
It fits 2-door and 4-door Jeep Wrangler JK models. Confirm fit for your vehicle’s year, model and trim before ordering.
The design addresses anti-dive for front braking, anti-squat for rear power transfer, and the front and rear roll centers. The upper and lower long FlexArms adjust for pinion, caster and tire position. Lower FlexArms are 2 inch OD by .281 wall DOM tube with welded heavy duty bushing eyelets.
Key features
- 4 inch Elite LCG long arm lift
- Fully adjustable upper and lower long FlexArms
- Adjustment for pinion, caster and tire position
- 2 inch OD by .281 wall DOM lower FlexArm tube
- Heavy duty CNC cut steel bracketry with gusseted and reinforced welds
- Front sway bar disconnects
- Max tire size 37×12.50
Choosing long arm geometry
Long arm suspension controls axle position with arms that mount to the frame and axle, so changing the lift also changes how those arms angle through the suspension travel. Pinion, caster and tire position need to be set together, because a change in one affects the others. Measure the setup after installation and recheck it after any adjustment or change in tire size.
A long arm lift often pairs with a driveline check, and JK models with this type of system need a driveshaft modification. Inspect the FlexArm bushings and bracket welds on a regular schedule, especially after rocky trail use. Clunks over bumps or uneven tire wear can point to a loose arm or worn bushing, and catching them early is simpler than a full repair.
- Measure pinion angle after each arm adjustment
- Inspect FlexArm bushings at every service interval
- Check sway bar disconnect operation before trail use
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1457400 |
| UPC | 843885021896 |
| Lift | 4 inch |
| Lift height range | 3 to 4.99 inches |
| Suspension type | Long arm |
| Rear lift method | Coil springs |
| Lower FlexArm tube | 2 inch OD, .281 wall DOM |
| Max tire size | 37×12.50 |
| Shocks | Not included |
Vehicle fitment
It fits the 2007–2015 Jeep Wrangler JK, including 70th Anniversary, Rubicon, Sahara, Sport, Unlimited 70th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited X and X models. It fits both 2-door and 4-door JK Wranglers.
Model years outside 2007–2015 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Driveshaft modifications are required on all JK Wranglers and Unlimited models with this suspension system. The bracketry is set against the frame locating holes and then stitch-welded in place, so the fit should be confirmed before the final welds.
What’s included
The kit includes the upper and lower long FlexArms, the heavy duty bracketry, front sway bar disconnects and the 2 inch lower FlexArm tube. Shocks are not included.
Not included: Shocks.







