Overview
The SPOD 600-0915 is a 6 Switch sPOD and Source System without Air Gauge for adding electrical upgrades to the Jeep Wrangler JK. Its stated purpose is to let a Jeep owner add upgrades without damaging the power system or cutting into factory installed wiring.
JK Wranglers have complex CAN-BUS electrical systems that make upgrades harder to install. This system is designed to solve that problem.
Key features
- 6 switch sPOD control setup
- Paired with a Source system for switch control
- Adds upgrades without cutting into factory installed wiring
- Built around the CAN-BUS electrical system of the JK Wrangler
Protecting the CAN-BUS wiring
Modern Jeeps route much of their control and sensor traffic over a CAN-BUS network, so an added accessory circuit can affect systems that were never meant to share its wiring. Upgrades that tap into the wrong conductor can cause warning lights, intermittent faults or accessories that behave unpredictably. Keeping the switch panel on its own dedicated path and avoiding splices into network wires is the most reliable approach for any JK owner.
Before installing, plan which accessories will run from each switch and how much current each one draws, so fuses and wire gauges match the loads. Take a few minutes to review the wiring diagram for your model year, since trims and options can differ. After installation, cycle the ignition and check for dash messages, then recheck connections after the first few trail trips where vibration can loosen terminals.
- Keep network wires free of splices
- Match each load to its fuse and wire size
- Check dash messages after the first start
Specifications
| Brand | SPOD |
|---|---|
| Part number | 600-0915 |
| UPC | 700007185381 |
| Switches | 6 |
| Air gauge | Air gauge is not included, since this is the version without one. |
Vehicle fitment
It is designed for 2007-2018 Jeep Wrangler JK models. For a TJ or JL, confirm fit before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The kit is a 6 Switch sPOD setup. Check the individual components against your installation before starting.
Not included: Air gauge.
















