Overview
The SPOD 2009–2017 JK model 6 Switch System with Source System and green switches is a plug-and-play accessory kit for the 2009 to 2017 Jeep Wrangler JK, Rubicon and Unlimited, in 2-door and 4-door models. It pairs six green double-light LED switches with the SPOD Source power distribution block.
This SPOD power block is fused and relayed, which makes adding an accessory a simpler job. It also has an integrated low-voltage cutoff that watches battery voltage and switches off each accessory once the battery falls below operating voltage. That keeps enough charge in the battery to start the vehicle.
The six switches use push-button activation, and the lower pilot lights are part of the panel. The lights come installed and pre-wired, so the panel is ready to mount once the harness is connected.
Key features
- Six double-light LED Contura switches in green, with push-button activation
- Lower pilot lights installed and pre-wired
- Fused and relayed Source power block, plug and play
- Integrated low-voltage cutoff that shuts off accessories when battery voltage drops
- Two-piece harness with 8 multi-color leads of 18 gauge wire
- Deutsch automotive connector on each end of the harness
- Wires wrapped in high-temperature, abrasion-resistant nylon braided sleeving
Wiring and battery care
A switch panel adds a steady load to the electrical system, so it helps to think about how accessories will be used. Lights left on while the engine is off can drain a battery, and the low-voltage cutoff in this system is there to protect starting power. Route the harness away from heat sources and moving parts, and secure it with the included brackets and hardware.
Check the connectors periodically, especially after off-road use, because mud and water can work into them. Keep the Deutsch connectors seated and clean, and look for chafing where the harness passes through body openings. A quick check of the battery voltage after a long day with accessories running is a good habit.
- Route the harness away from heat and moving parts
- Inspect connectors after off-road use
- Check battery voltage after long accessory use
Specifications
| Brand | SPOD |
|---|---|
| UPC | 816482020487 |
| Switch count | Six double-light LED switches |
| Switch color | Green |
| Harness | Two pieces, 8 multi-color leads, 18 gauge |
| Connectors | Deutsch automotive, both ends |
| Low-voltage cutoff | Integrated |
| Mounting | Brackets and hardware included |
Vehicle fitment
It is a six-switch kit for 2009–2017 Jeep Wrangler JK models, including Rubicon and Unlimited in 2-door and 4-door bodies.
Other Wrangler generations, including the Wrangler JL, and JK years outside 2009 to 2017 are not covered by the stated years. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The lights are pre-wired and the harness uses Deutsch connectors on both ends, so the kit is ready to connect. All required mounting brackets and hardware are included with the kit.
What’s included
The kit includes the six-switch panel with pre-wired lights, the SPOD power block, the two-piece harness with its connectors, and the mounting brackets and hardware.


















