Overview
The SPOD 2009–2017 JK model 6 Switch System with Source System and red switches is a complete accessory kit for the 2009 to 2017 Jeep Wrangler JK, including Rubicon and Unlimited models with 2 or 4 doors. It has six red double-light LED switches mounted on a panel and powered by the SPOD Source block.
This SPOD block is fused and relayed, which is what makes adding accessories straightforward. An integrated low-voltage cutoff monitors battery voltage and turns off each accessory when the battery drops below its operating level, so the battery keeps enough voltage to start the vehicle.
Each red switch has push-button activation, and the panel includes lower pilot lights. The lights are installed and pre-wired at the factory, so the kit arrives ready to install.
Key features
- Six double-light LED Contura switches in red, with push-button activation
- Lower pilot lights installed and pre-wired
- Fused, relayed and plug-and-play Source power block
- Integrated low-voltage cutoff for battery protection
- Two-piece harness with 8 multi-color leads of 18 gauge wire
- Deutsch automotive connectors on each end
- Abrasion-resistant nylon braided sleeving on all wires
Wiring and switch layout
A switch panel is only as useful as its wiring, so plan the layout before mounting anything. Choose a location where the switches are easy to reach from the driver seat and where the panel will not block airbags, the shifter or the parking brake. Route the harness away from sharp edges, moving linkage and exhaust heat, and secure it with clips at regular intervals so it does not rub or pull loose on rough trails.
Because the SPOD Source block provides fused and relayed power, each accessory can draw current without loading the stock wiring. Keep the battery terminals clean and tight, since a weak connection can make a fused accessory cut out early. After installation, cycle each switch and confirm its light comes on before closing up the dash.
- Test each switch and pilot light before final trim installation
- Keep connector seals clean and dry in wet or muddy conditions
- Recheck clip positions after the first few trail runs
Specifications
| Brand | SPOD |
|---|---|
| UPC | 6000915LTLEDRII |
| Switch count | Six double-light LED switches |
| Switch color | Red |
| Harness | Two pieces, 8 multi-color leads, 18 gauge |
| Connectors | Deutsch automotive, both ends |
| Low-voltage cutoff | Integrated |
| Mounting | Brackets and hardware included |
Vehicle fitment
The kit fits 2009 to 2017 Jeep Wrangler JK models, including Rubicon and Unlimited versions with 2-door and 4-door bodies.
Wrangler JL and Wrangler JK years before 2009 or after 2017 are outside the stated years. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the lights are pre-wired and the harness ends in Deutsch connectors, the harness is ready to connect to the SPOD block. The mounting brackets and hardware for the panel are included.
What’s included
The kit comes with the six red-switch panel, pre-wired lights, the SPOD block, the two-piece harness and the mounting brackets with hardware.














