Overview
The Skyjacker D200CS is a front Softride leaf spring for 1987 to 1993 Dodge W250 and W350 Base trucks. The single progressive multileaf spring carries a 0 to 4.99 inch lift rating and comes without bushings; Skyjacker recommends bushing part number SKYSE12D.
The spring is made from American steel and has a load capacity at least equal to the OE specification. It carries a Limited Lifetime Warranty.
Key features
- Front position, single spring
- Progressive multileaf packs
- American steel.
- Lift rated for 0 to 4.99 inches
- Recommended bushing SKYSE12D; bushings not included
Matching the spring to your load
A front leaf spring sets how much weight the front axle carries and how the nose sits when the truck is unloaded or towing. Progressive multileaf packs begin soft under light loads and stiffen as the load rises, which suits a truck that sees both daily driving and heavier work. Choosing a spring is mostly about how the truck will be used, so match the spring to typical loads rather than the largest load you might ever carry.
Front springs rarely work alone. Shock absorbers, bump stops and the bushings at the spring eyes all affect how the new spring settles, and worn parts left in place can make a fresh spring feel off. Inspect those components while the axle is supported, and note any drop in height on one side before you reassemble.
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | D200CS |
| UPC | 803696122182 |
| Product line | Softride leaf spring |
| Position | Front |
| Spring quantity | Single spring |
| Bushings included | Not included |
| Recommended bushing | SKYSE12D |
| Lift height range | 0 to 4.99 inches |
| Fitment | Direct fit |
| Material | American steel |
| Warranty | Limited lifetime |
Vehicle fitment
It fits 1987 to 1993 Dodge W250 and W350 Base trucks.
Ramcharger and other Dodge W-series models are not on this list, and Dodge trucks from 1994 onward fall outside the listed years. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the bushings are separate, confirm that the SKYSE12D bushing matches your setup before starting. A front spring swap usually calls for a caster and alignment check afterward. Support the front axle on stands before pulling the old spring pack.
What’s included
One front leaf spring.
Not included: bushings, and a second spring for the other side.





