Overview
The Skyjacker DR60S is a rear Softride leaf spring for selected Dodge Ramcharger, Dodge W-series and Plymouth Trailduster trucks built from 1972 through 1993. Skyjacker builds it as a progressive multileaf pack and rates it for a lift height range of 5 to 6.99 inches. Skyjacker labels it direct fit, so it is intended to replace the original rear spring on the trucks it lists.
The load capacity is equal to or greater than original equipment, and the spring is made with American steel. Rubber bushings come pre-installed. Each part number covers one spring, so a matched pair needs two. A limited lifetime warranty applies to the spring.
Key features
- Progressive multileaf pack construction
- Load capacity equal to or greater than original equipment
- American steel
- Rubber bushings pre-installed
- Lift height range of 5 to 6.99 inches
- Rear position for the rear axle
- Direct fit to the trucks in its coverage
- Limited lifetime warranty
Pinion angle after a lift
A rear spring change alters the position of the axle relative to the driveshaft, and that changes the pinion angle. When the angle becomes too steep, the U-joints can wear early and the driveline can vibrate at speed. Measuring the angles after the job gives a clear picture of what the new spring has done, and it is much easier to address during installation than after the truck has been driven for a while.
Older Dodge and Plymouth trucks often have worn bushings and tired shock mounts, so those parts deserve a look before the spring goes in. Keep the truck on stands while the original spring is removed, and take care with the brake lines, which can be stretched by a height change.
- Measure driveline angles before and after the lift
- Inspect U-joints for play
- Check brake lines for stretch
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | DR60S |
| UPC | 803696127637 |
| Product type | Softride leaf spring |
| Position | Rear |
| Spring quantity | Single spring |
| Bushings included | Yes, rubber bushings pre-installed |
| Lift height range | 5 to 6.99 inches |
| Construction | Progressive multileaf packs |
| Material | American steel |
| Fitment type | Direct fit |
| Warranty | Limited lifetime, from Skyjacker |
Vehicle fitment
It fits these trucks and trims:
- Dodge Ramcharger, 1974–1993 (Base, Canyon Sport, Royal SE, SE)
- Dodge W100, 1972–1977 and 1986–1989 (Custom, Pickup Base)
- Dodge W150, 1977–1993 (Base, S)
- Dodge W200, 1972–1980 (Base, Pickup Base)
- Dodge W250, 1981–1993 (Base)
- Plymouth Trailduster, 1974–1981 (Base)
Dodge and Plymouth models outside these years and series are not on the list, including any Dodge model year after 1993. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the bushings are pre-installed, check them for wear before mounting the spring. Changing rear spring height changes pinion angle, so measure driveline angles after the lift and correct them if needed. Keep the truck supported on jack stands while the original spring is removed.
What’s included
One Skyjacker Softride rear leaf spring, part number DR60S, with pre-installed rubber bushings.
Not included: Other suspension hardware is not included.






