Overview
The Skyjacker J20FS is a front Softride leaf spring for Jeep CJ5 models from 1976 to 1983, CJ7 models from 1976 to 1986 and Scrambler models from 1981 to 1985. It has a lift height range of 0 to 4.99 inches and is designed for use with 2.5 inch lifted springs.
The spring is made from American steel, and each leaf is shot-peened with hardened steel pellets at high velocity. Shot-peening builds tensile strength into the leaves, which supports full wheel travel over the life of the spring. Bushings are not included with this part.
Key features
- American steel construction
- Each leaf shot-peened with hardened steel pellets
- Front position, single spring
- Lift height range of 0 to 4.99 inches
- Designed for use with 2.5 inch lifted springs
- Direct fit designation from Skyjacker
Front spring setup notes
Front leaf springs locate the axle and carry much of the vehicle’s weight on the front end, so they influence steering response, caster and how level the truck sits. When a spring is replaced, the front alignment should be checked afterward, and the shock absorbers may need a look if the new spring changes ride height.
Because bushings are not supplied with this spring, sourcing a matched set beforehand avoids delays. Inspect the spring perches, U-bolts and shackle hardware while the axle is down. Worn hardware can allow the spring to shift, which changes steering feel and causes uneven front tire wear.
Older CJ chassis often show fatigue in the leaves over the decades, so check for cracked or broken leaves, sagging on one side and noticeable loss of arch before deciding the spring still works.
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | J20FS |
| UPC | 80369614394 |
| Product type | Softride leaf spring, front |
| Spring quantity | Single spring |
| Material | American steel |
| Leaf treatment | Shot-peened |
| Bushings | Not included |
| Lift height range | 0 to 4.99 inches |
| Use with | 2.5 inch lifted springs |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for 1976 to 1983 Jeep CJ5 models in the Base, Golden Eagle, Laredo, Limited and Renegade trims, 1976 to 1986 Jeep CJ7 models in the Base, Golden Eagle, Golden Hawk, Laredo, Limited and Renegade trims, and 1981 to 1985 Jeep Scrambler models in the Base, Laredo, Renegade, SL and SR trims.
Model years outside these ranges are not covered, and the rear position is a different part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because bushings are not included, matching bushings must be obtained separately before installation. Match the spring to your planned lift, since Skyjacker specifies 2.5 inch lifted springs for this part.
What’s included
One Skyjacker Softride front leaf spring, part number J20FS.
Not included: bushings.







