Overview
The Skyjacker JK2717B is a dual load carrying ball joint kit, part number SKYJK2717B, for the Jeep Wrangler JK. It fits 2007–2018 Wrangler models in both 2-door and Unlimited 4-door versions, across the trims this kit covers. It is a direct fit and is lubeable.
A ball joint is the swivel point between the spindle or knuckle and the rest of the suspension, and it has a round head that turns inside a cup-shaped socket. Most front suspensions use an upper and a lower joint on each wheel, and worn joints are replaced in pairs or as a full set once the wear pattern shows. Upper ball joints are also used on some 4WD vehicles with solid axles, where they connect the knuckle to the axle, and lower joints are used in the same way on those axles.
Key features
- Dual load carrying design for higher loads from larger tires and heavier builds.
- Lubeable joint, so grease can be added on a regular schedule
- Heat-treated ball stud mounted inside a steel housing
- Ball stud that swings and rotates in the housing to let the knuckle pivot
- Clears RCV axle shafts
Ball joint wear and replacement
Ball joints carry the weight of the front end and let the knuckle pivot for steering, so play in a joint shows up as wandering, loose steering or uneven tire wear. A dual load carrying design is meant to handle higher loads from larger tires and heavier builds, but it still wears like any other joint. Inspection should check the boot, the grease fitting and any movement under a jack.
Replace joints in pairs on the same axle so both sides wear evenly and steering feel stays consistent. Ball joints often get replaced alongside tie rod ends, control arm bushings and the steering stabilizer when the front end is opened up. After installation, have the alignment checked, since joint replacement changes front geometry.
- Torn or cracked boots
- Visible play when the wheel is lifted
- Uneven or cupped tire wear
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | SKYJK2717B |
| Type | Ball joint kit, dual load carrying |
| Lubeable | Yes |
| Fitment | Direct fit |
| Axle clearance | Clears RCV axle shafts |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK), including the 70th, 75th and Anniversary editions, the Rubicon, Sahara, Sport and Sport S, the Unlimited versions and the X models.
Wrangler TJ, LJ and JL models, and the earlier YJ generation, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Greasing the ball joint regularly extends its life, so the grease fitting is the main maintenance point. Check the joints for play when the front end is serviced, and replace them when the wear pattern calls for it.
What’s included
A ball joint kit, part SKYJK2717B, supplied as a kit rather than a single joint. The joints are lubeable.









