Overview
The Moog K80771 is a press-in front lower ball joint, part number MOGK80771, for the 2006–2010 Ford Explorer and Ranger, the 2007–2010 Ford Explorer Sport Trac, the 2006–2010 Mercury Mountaineer, and the 2002–2007 and 2002–2009 Mazda B3000 and B4000.
The lower joint is the pivot at the bottom of the front suspension, so wear shows up as looseness or uneven tire wear. This greasable replacement has a hardened ball stud and a forged housing, and its design has been updated, so the part may look different from earlier versions.
Key features
- Press-in type for installation into the knuckle
- Hardened ball stud made of materials Moog says are OE equivalent or better
- Dust boot with an encapsulated Belleville washer to control movement
- Gusher bearing design that lets grease reach the stud
- Greasable socket that flushes contaminants out
- Pre-tapped grease fitting hole for easier maintenance
Signs of a worn joint
A worn lower joint on a Ford Explorer or Ranger often shows up as steering wander, a clunk over rough road, or tire wear along the inside edge. The joint is a pivot under load, so play develops slowly and may only be noticed during a turn. Checking with the wheel raised and the joint loaded gives a clearer picture than a visual look.
Press-in replacement needs the old joint pressed out of the knuckle and the new one seated square. Clean the bore before installing and inspect it for cracks. Grease the new joint through the pre-tapped fitting after installation, then inspect the upper joint and tie rod ends at the same visit.
- Check for clunks over rough road
- Look for inside-edge tire wear
- Inspect the bore for cracks before pressing
Specifications
| Brand | Moog |
|---|---|
| Part number | MOGK80771 |
| Position | Front lower |
| Joint type | Press-in |
| Lubeable | Yes |
| Housing | Forged, with up to 52% more material in key areas |
Vehicle fitment
It fits the 2006–2010 Ford Explorer (Eddie Bauer, Limited, XLS, XLT), the 2007–2010 Ford Explorer Sport Trac, the 2006–2010 Ford Ranger, the 2002–2007 Mazda B3000, the 2002–2009 Mazda B4000 and the 2006–2010 Mercury Mountaineer.
Ford and Mercury models from other years, and Mazda B-Series years outside 2002 to 2009, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a press-in joint, so the old joint has to be pressed out and the new one pressed into the knuckle. A press or the correct tools are needed for that step.
What’s included
One Moog front lower ball joint, part MOGK80771.










