Overview
The Skyjacker YJ45FS is a Rock Ready double wrap front leaf spring for the 1987–1995 Jeep Wrangler (YJ). It is sold individually and is built for use with 4 inch lifted springs, with a lift height range of 0 to 4.99 inches.
Skyjacker says its leaf springs use only American steel, with each leaf shotpeened using hard steel pellets at very high velocities. The brand explains that shotpeening compresses the steel surface and raises tensile strength, and that without it, maximum wheel travel and ride quality could not be achieved without sacrificing spring life.
The springs use bolt style clips, which Skyjacker describes as eliminating friction, while cinch style bend clips can bind over the leaves. Each spring is tapered across the full leaf width, a design the brand says flexes the leaf ends more and spreads loads over a greater area.
Key features
- Rock Ready double wrap front leaf spring
- Sold individually
- Used with 4 inch lifted springs
- American steel with individually shotpeened leaves
- Bolt style clips for reduced friction
- Full-width taper for flex at the leaf ends
- Lift height range of 0 to 4.99 inches
Front spring condition and wear
A front leaf spring carries much of the vehicle’s weight and controls how the axle moves over bumps and through articulation. On a lifted Wrangler YJ, the spring also sets front ride height, so a change in arch or spring rate alters how the front end sits. The leaves, clamps and bushings work together, so the spring’s condition depends on all three.
Worn leaves often show as sag, a shifted center bolt, or leaves that rub or separate near the ends. Inspect the spring for cracks, check the clip bolts for looseness, and look for uneven height side to side. Eye bushings wear over time and let the spring move more than intended, which can change steering feel and alignment, so they are usually replaced with the spring.
- Look for cracked or separated leaves
- Replace worn eye bushings during the same job
- Recheck clip and U-bolt fasteners after the first drives
- Recheck alignment after the install
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | YJ45FS |
| UPC | 803696169835 |
| Product line | Rock Ready |
| Style | Double wrap front leaf spring |
| Mounting location | Front |
| Sold | Individually |
| Spring quantity | Single spring |
| Bushings included | Not included |
| Lift height range | 0 to 4.99 inches |
| Leaf material | American steel, shotpeened |
| Clip style | Bolt style |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 1987–1995 Jeep Wrangler (YJ) in the Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims. On a YJ running 4 inch lifted springs, check that the lift falls within the range above before installing.
Its fit covers the 1987–1995 YJ. For TJ, LJ or JK Wranglers and Cherokee or Grand Cherokee models, check your year, model and trim against the fitment before ordering.
Installation notes
Bushings are not included, so inspect the bushings on your vehicle and replace any worn ones before the spring goes in. Match the other front suspension parts to the 4 inch lift, plan a front alignment and a driveline angle check afterward, and support the vehicle on jack stands before removing the old spring.
What’s included
One Skyjacker YJ45FS Rock Ready double wrap front leaf spring, sold individually.
Not included: Bushings.




