Overview
The Skyjacker YJ40FSB is a front Sportride leaf spring for a 4 inch lift on the 1987–1995 Jeep Wrangler (YJ). It is sold as a single spring with a lift height range of 0 to 4.99 inches, and it is a direct fit for the YJ.
Each leaf is made from American steel and shot peened with hard steel pellets fired at high velocity. Peening compresses the leaf surface and raises tensile strength, which supports wheel travel and ride quality without shortening spring life.
The leaves taper across their full width, which Skyjacker says creates more flex at the leaf ends and spreads loads over a greater area. That taper is meant to reduce the tendency of one leaf to dig into the leaf above it.
Key features
- Sportride front leaf spring designed for a 4 inch lift
- Sold as a single spring
- American steel leaves, each individually shot peened
- Bolt style spring clips, which the brand says reduce friction and binding
- Springs taper over the full leaf width for more flex at the leaf ends
- Lift height range of 0 to 4.99 inches
- Direct fit for the 1987–1995 Jeep Wrangler (YJ)
Sportride geometry and wear
The Sportride design depends on its tapered leaves and bolt-style clips to balance flex and friction. Tapered leaves spread load and let the ends move more freely, so inspect the leaf tips and the center bolt for wear as well as for cracks. A spring that has been on the vehicle for years can take a set, which shows as a front end that sits uneven.
Front bushings and spring mounts should be looked at during any front spring change. Worn bushings allow the axle to shift and can cause clunks over bumps, while worn mounts change alignment. Replacing these parts during the same job is simpler than returning to the front end later, and a fresh alignment should follow the install.
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | YJ40FSB |
| UPC | 803696212753 |
| Product line | Sportride leaf spring |
| Mounting location | Front |
| Spring quantity | Single spring |
| Bushings included | Not included |
| Lift height range | 0 to 4.99 inches |
| Leaf material | American steel, shot peened |
| Clip style | Bolt style |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 1987–1995 Jeep Wrangler (YJ) in the Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims. Compare the existing springs and bushings with this part number before ordering.
It fits the 1987–1995 Wrangler YJ. Check your year, model and trim before ordering, since the TJ, LJ, JK and Cherokee models are different vehicles.
Installation notes
Bushings are not included, so check the spring bushings on your vehicle and obtain replacements separately if they are worn. Because the spring changes front ride height, have the front alignment checked after installation and inspect driveline angles. Support the vehicle securely on jack stands before removing the stock front spring.
What’s included
One Skyjacker YJ40FSB front leaf spring, sold as a single spring.
Not included: Bushings.







