Overview
The Skyjacker YJ25FS is a 2.5 inch front double wrap leaf spring for the 1987–1995 Jeep Wrangler (YJ). It is a single spring for the front axle, designed for use with 2.5 inch lifted springs, with a lift height range listed at 0 to 4.99 inches.
Softride leaf springs are made from American steel, and each leaf is shot peened with hard steel pellets at high velocity. Peening compresses the steel surface to raise tensile strength, which supports more wheel travel and better ride quality without shortening spring life. The springs use bolt-style clips rather than cinch-style bend clips, which reduces binding and friction between the leaves.
Key features
- American steel leaves, per Skyjacker’s Softride construction
- Shot peened leaves, which the brand says increases tensile strength
- Bolt-style spring clips that avoid the binding of cinch-style clips
- Leaves tapered across the full width to spread loads over a larger area
- Double wrap design for the 2.5 inch rock ready lift range
Leaf spring maintenance basics
A leaf spring is a stack of steel plates held together at the center. Over time the leaves can shift, rust or crack, especially where moisture collects between them. Periodic inspection of the center bolt, the leaf ends and the clips helps catch problems before the spring loses its arch and before the ride becomes uneven.
Bolt-style clips are simpler to inspect than cinch-style clips because the leaves stay in position under the clip. Look for rust and debris at the leaf ends, and clean them before reinstalling. A suitable protective coating can help slow corrosion when a spring is exposed to road salt and mud over several seasons.
- Inspect the center bolt for looseness
- Clean debris from between the leaves
- Check clips for wear or missing hardware
- Re-check hardware after the first hard off-road run
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | YJ25FS |
| UPC | 803696169880 |
| Position | Front |
| Spring quantity | Single spring |
| Spring design | Double wrap leaf spring |
| Lift height range | 0 to 4.99 inches |
| Lift compatibility | Designed for use with 2.5 inch lifted springs |
| Bushings included | No, bushings not included |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 1987–1995 Jeep Wrangler (YJ), covering the Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
It fits the 1987–1995 Wrangler YJ only, so the later TJ, LJ, JK and JL Wranglers, the Cherokee and other Jeep models fall outside its scope. Check year, model and trim before ordering.
Installation notes
Spring bushings are not included, so check that you have the bushings your mounting setup requires before starting the install. Because the spring is designed for 2.5 inch lifted springs, confirm the rest of the front suspension is set up for that lift, then check alignment and driveline angles after installation. Support the vehicle securely on jack stands while the old spring is removed.
What’s included
One Skyjacker YJ25FS front leaf spring, sold individually.
Not included: Spring bushings. Bushings are not included with this spring.





