Overview
The Rubicon Express RE3791-1 is a small size Super-Flex joint, a cartridge-style joint assembly for upper control arms. It fits directly into the factory front or rear upper control arm mounting points on the XJ, MJ, ZJ, TJ and WJ Jeep chassis: the Cherokee (XJ), Comanche (MJ), Grand Cherokee (ZJ), Wrangler (TJ) and Grand Cherokee (WJ).
Rubicon Express designed the Super-Flex cartridge to replace the heim joints used in its early suspension designs. It uses UHMW side races and a threaded adjuster nut, which allows tightening and rebuilding. A joint of this design can be tightened as it wears, and the cartridge can be rebuilt rather than replaced outright.
Key features
- Small size Super-Flex joint cartridge
- 1/2 in. ID ball
- UHMW side races
- Threaded adjuster nut for tightening and rebuilding
- Serviceable design
- Designed to replace heim joints in early Rubicon Express suspension designs
Rebuilding and setting preload
On an upper control arm, the joint lets the arm pivot while the axle moves through its travel. The ball, races and adjuster determine how smoothly that happens, and a joint that binds or has play will change how the axle is located. Because the joint carries load in more than one direction, its condition matters on and off the road.
When rebuilding, tighten the adjuster until the joint moves without binding, then back it off slightly and secure the nut. Check for play with the arm installed and the vehicle safely supported. After any joint work, have the alignment checked, since changes to arm geometry affect caster and toe. Inspect for worn races and a loose adjuster after trail use.
- Smooth movement through full articulation
- No binding or clicking at the joint
- Adjuster nut secured after each change
- Alignment checked after reassembly
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE3791-1 |
| UPC | 614901440935 |
| Joint size | Small |
| Ball ID | 1/2 in. |
| Side races | UHMW |
| Adjuster | Threaded nut |
| Joint details | Weld-on joint kit |
| Maintenance | Serviceable |
Vehicle fitment
It is for the factory front or rear upper control arm mounts on these Jeep chassis: XJ (Cherokee, 1984-2001), MJ (Comanche, 1986-1992), ZJ (Grand Cherokee, 1993-1998), TJ (Wrangler, 1997-2006) and WJ (Grand Cherokee, 1999-2004). The years are the ranges for those chassis codes.
Fitment covers the XJ, MJ, ZJ, TJ and WJ chassis listed above. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The threaded adjuster nut lets you tighten the joint or rebuild it without replacing the whole control arm. It is a serviceable joint and a weld-on joint kit, so work out how the joint is mounted on your arm before buying.
What’s included
The package is one Super-Flex joint assembly.
Not included: control arms and welding supplies.
