Overview
The Rubicon Express RE3792 Super-Flex assembly is a weld-on, serviceable joint cartridge for the factory front or rear lower control arm mounts on XJ, MJ, ZJ, TJ and WJ Jeep chassis.
Rubicon Express designed the cartridge to replace the heim joints used in its early suspension designs. It is sized to fit directly into the factory mounting points, and it uses UHMW side races with a threaded adjuster nut, so it can be tightened and rebuilt when needed.
The cartridge is designed to hold its adjustment over extended use, which can make it a practical alternative to factory rubber bushings in hard-use applications.
The part is a universal builder part, and its fit is set by the chassis it is designed for. The fitment section below covers those chassis by year.
Key features
- Fits the factory front or rear lower control arm mounts
- UHMW side races
- Threaded adjuster nut for easy tightening
- Serviceable, and can be rebuilt if necessary
- Weld-on joint kit
- Replaces the heim joints used in early Rubicon Express suspension designs
Keeping control arm joints tight
Control arm joints carry the load of the axle and the steering path, so small looseness at the mount shows up quickly as wander or clunks. A threaded adjuster nut lets you take out play as the joint wears, but it is best used as a planned maintenance step rather than a fix for a damaged mount. Check that the joint still turns freely before tightening the nut all the way.
Before welding a joint into place, confirm that the mount is clean, straight and matched to the joint’s outside diameter. Weld heat can distort thin mounts, so fit the joint, check alignment and let the metal cool before final torque. Greasing is worth planning for, since a serviceable joint lasts longer when it is kept clean and lubricated.
- Inspect control arm mounts for cracks before welding
- Keep the joint clean and lubricated
- Check the adjuster for smooth travel
- Re-check nut tension after first off-road use
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE3792 |
| UPC | 614901440942 |
| Type | Super-Flex joint cartridge assembly |
| Joint details | Weld-on joint kit |
| Maintenance | Serviceable |
| Race material | UHMW side races |
| Adjustment | Threaded adjuster nut |
| Mounting | Factory front or rear lower control arm mounts |
| Chassis | XJ, MJ, ZJ, TJ, WJ |
Vehicle fitment
Fitment follows the XJ, MJ, ZJ, TJ and WJ Jeep chassis. That covers Cherokee (XJ) 1984 to 2001, Comanche (MJ) 1986 to 1992, Grand Cherokee (ZJ) 1993 to 1998, Wrangler (TJ) 1997 to 2006 and Grand Cherokee (WJ) 1999 to 2004.
The chassis list does not include Wrangler JK or JL models, or the Liberty (KJ). Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The joint kit is weld-on, so installation is a fabrication job rather than a bolt-in swap. Welding a suspension mount should be left to an experienced fabricator. The threaded adjuster nut sets preload, so adjust it before the final assembly.
What’s included
One Super-Flex assembly (RE3792) with its weld-on joint kit, threaded adjuster nut and UHMW side races.
Not included: the control arms that the joint installs into.


