Overview
The Currie CE-9102K is a front end housing kit that lets 2-inch Johnny Joints replace the stock upper control arm bushings on a 1991 to 2001 Jeep Cherokee (XJ). It works on stock Dana 30 or 44 housings and most aftermarket front end housings.
The kit moves the upper joint onto a flame-cut steel upright, 1 inch thick, which fits on the tube side with a Johnny Joint already installed. A separate insert fits the gear case ear, and an installation tool is included. The upright welds to the existing bracket base rather than to the tube, which helps avoid warping the tube.
Key features
- Allows a 2-inch Johnny Joint with 7/16 inch stock-size thru bolts on a front end housing
- Works on stock Dana 30 or 44 housings and most aftermarket housings
- Tube-side upright is 1 inch thick flame-cut steel with a Johnny Joint already installed
- No welding on the tube, so the tube is not warped
- Includes greasable hardware and an installation tool
- Mounts in the front upper position
Upper joint geometry and wear
The upper joint on a front end controls how the upper arm moves relative to the axle, so its position affects caster, travel and the way the suspension articulates. When a stock bushing is replaced with a joint, the arm moves in a different arc, and that change can alter the feel of steering and the angle of the joint under load. Plan the joint position with that in mind rather than treating it as a simple swap.
Because a housing kit moves the pivot, the rest of the front end may need to be checked, including the track bar, tie rod and steering geometry. Keep the greasable hardware clean and fresh, and inspect the joint after rough trails for play, cracked welds at the upright and bent brackets. Replace worn parts together so the new joint is not sitting on a tired mount.
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9102K |
| UPC | 70000305705 |
| Kit type | Front end housing kit for Johnny Joints |
| Joint size | 2 inch Johnny Joint |
| Thru bolt | 7/16 inch, stock size |
| Upright thickness | 1 inch |
| Upright material | Flame-cut steel |
| Position | Front upper |
| Hardware | Greasable |
Vehicle fitment
The kit fits the Jeep Cherokee (XJ) from 1991 through 2001. Confirm fit against your vehicle’s year, model and trim before ordering.
Model years before 1991 and after 2001 fall outside the stated range. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit requires cutting and welding equipment. Cut off the top of the stock bracket on the tube, set the Currie upright into the existing bracket base and weld it there. Only attempt the welding if you are trained for it, since the welds sit on a suspension bracket.
What’s included
A Johnny Joint insert for the gear case ear, the steel upright with a Johnny Joint already installed, greasable hardware and an installation tool.
Not included: cutting and welding equipment, which installation requires.












