Overview
The Fabtech FTS94051 is a rear heavy duty CV-style drive shaft in an extended length. It fits the 2007–2011 Jeep Wrangler (JK) in the 70th Anniversary, Rubicon, Sahara, Sport and X trims.
Fabtech says CV and heavy duty style driveshafts are needed with some lift kits. This shaft is the rear position, and its specifications say it does not require a slip yoke eliminator.
Key features
- Rear drive shaft in heavy duty CV style
- Extended length
- No slip yoke eliminator required
- Fits the 2007–2011 Wrangler JK trims shown below
Driveline angles on lifted JKs
On a lifted Wrangler JK, the driveline angles change because the axle sits in a different position relative to the transfer case. A CV style shaft handles those changing angles better than a standard shaft with a fixed joint, which is why it is common on lifted trucks. The extended length is meant to cover the added distance created by the lift, so the existing rear driveline should be measured before fitting. Measure both ends and compare the length to the old shaft.
Rear shafts share the axle and differential with the brake and suspension parts, so inspect the pinion yoke and axle seal while the shaft is off. Replace worn U-joints or a damaged yoke at the same time, since a new shaft on worn joints will wear out quickly. After installation, check for vibration at highway speed and make sure the shaft has clearance at full suspension compression.
- Measure the driveline before ordering
- Inspect the pinion yoke and axle seal
- Check clearance at full compression
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS94051 |
| UPC | 674866021099 |
| Length | Extended |
| Joint type | CV |
| Construction | Heavy duty |
| Position | Rear |
| Slip yoke eliminator | Not required |
| Fitment type | Universal fit |
Vehicle fitment
The shaft fits the 2007–2011 Jeep Wrangler (JK) 70th Anniversary, Rubicon, Sahara, Sport and X trims.
The list does not include the 2012 and later Wrangler JK years, the TJ or the LJ. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shaft is intended for lifted JK vehicles where a CV design is needed to manage the driveline angle, so measure the existing rear driveline before fitting the extended length.
What’s included
One rear drive shaft. Mounting hardware is not included.








