Overview
The Rubicon Express RE7515M is a 5.5 inch Extreme-Duty long arm lift kit with a rear Tri-Link and mono tube shocks for the 2003–2006 Jeep Wrangler TJ. The lift height range is 5 to 6.99 inches.
The kit replaces the stock suspension arms with longer control arms. Rubicon Express designed it as a complete suspension replacement that improves lifted geometry, adding stability on and off road over a standard short arm lift.
The rear Tri-Link replaces the rear track bar, letting the axle move without a side bar. It adds anti-squat for steep climbs, and the Builder Ball misalignment joint works with it.
Key features
- 5.5 inch lift with a listed range of 5 to 6.99 inches
- Chromoly long arms built from 4130 chromoly tubing
- Rear Tri-Link that replaces the rear track bar
- Builder Ball misalignment joint, rated for up to 32 degrees
- Adjustable control arms with serviceable Super-Flex spherical ball joints
- Mono tube shocks included
- Tuned lift springs and stainless steel brake lines
Mono tube shock considerations
Mono tube shocks use a single tube with a separate gas chamber, which is why they are often chosen for steady damping during repeated hard use. On a long travel lifted Jeep, that steadier feel can help on long washboard stretches where heat builds in the shock.
Monitor the shocks after the first few trail trips. Look for fluid on the shaft, loose or cracked mounting eyes and bushings that have worn out. Keep the shock mounts clean and check that travel is not limited by the bump stops or brake lines.
When the stock setup is replaced, shock length and mount position must match the new arms and Tri-Link. Do not reuse worn hardware from the old suspension.
- Check shock eyes for cracks
- Replace worn bushings in matched pairs
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7515M |
| UPC | 614901452969 |
| Lift height range | 5 to 6.99 inches |
| Suspension type | Long arm |
| Kit type | Extreme-Duty long arm |
| Rear lift method | 3-link (Tri-Link) |
| Control arm material | 4130 chromoly, .250 wall |
| Misalignment joint | Builder Ball, up to 32 degrees, 3 inch OD housing |
| Shocks included | Yes, mono tube |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2003–2006 Jeep Wrangler (TJ), including the 65th Anniversary Edition, Rubicon, SE, Sahara and Sport models.
Fit covers 2003–2006 TJ models only. Compare model year and trim with your own Jeep before ordering.
Installation notes
A 5 to 6.99 inch lift changes alignment and driveline angles, so both need checking once installed. The kit bolts on to factory Dana 35 and Dana 44 rear axles.
What’s included
The kit includes front and rear control arms, the rear Tri-Link, the Builder Ball, mono tube shocks, tuned lift springs, PT-Meg Super-Ride bushings, stainless steel brake lines and a three-piece belly pan.


