Overview
The Rubicon Express 4.5 Inch Extreme-Duty Long Arm Lift Kit with Rear Track Bar, No Shocks (part number RE7214), is a long arm suspension lift for the 2003–2006 Jeep Wrangler TJ. The stated lift height range is 3 to 4.99 inches, and shock absorbers are not included.
The long arm design replaces the factory arms with longer control arms, which improves lifted geometry. That geometry adds stability on and off road, and the extended arms are built for trail use.
Shock absorbers are not part of this kit, so choose a shock sized for the 3 to 4.99 inch range. Tuned lift springs and a rear track bar are included. Check whether new brake lines are needed before the long arms are installed.
Key features
- Chromoly long arms
- PT-Meg Super-Ride bushings
- Adjustable control arms with serviceable Super-Flex spherical ball joints
- Tuned lift springs
- Rear track bar included
- Three-piece belly pan for transfer case and transmission access
Choosing shocks for this lift
A long arm lift moves the axle on longer control arms, so the geometry at both ends of the vehicle changes once the kit is in. Shock length and damping matter more after a lift because the wheels travel through a different range. When picking shocks for this range, look for units built for the height you run and for your tire size. Mismatched shocks can bottom out or limit droop, so measure the old units before ordering.
Long arms, springs and the track bar are often replaced together, because the track bar bracket and the alignment depend on the new arm position. After installation, recheck the bolts once the vehicle has been driven a short distance, and have the alignment set by a shop that works on lifted trucks. Watch the shock mounts and the bushings for wear over time, especially on trail-driven Wranglers.
- Shock length matched to the lift height
- Brake line length checked after the install
- Bushing and ball joint wear inspected each season
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7214 |
| Lift height range | 3 to 4.99 inches |
| Suspension type | Extreme-Duty long arm |
| Rear lift method | Coil springs |
| Shock absorbers | Not included |
| Fitment type | Direct fit |
Vehicle fitment
This kit installs on 2003–2006 Jeep Wrangler (TJ) models, across the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
The 1997–2002 TJ and the LJ Unlimited are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Since no shocks are supplied, the shocks should be selected for the 3 to 4.99 inch range before the install. The long arms replace the factory arms, so the alignment should be set afterward. Check the shock mounts and the track bar bracket fit before the arms are fully tightened.
What’s included
Tuned lift springs, chromoly long arms, PT-Meg bushings and Super-Flex spherical ball joints, a rear track bar and a three-piece belly pan.
Not included: shock absorbers.


