Overview
The Rubicon Express RM12050 is a 1.25-inch female rod end coupler with a 1-1/4-inch-12 right-hand thread. It replaces a damaged rod end on a tube with a 1-1/4-inch minimum inside diameter.
Neither the joint nor the jam nut comes with this coupler, so supply both before installation.
Key features
- 1-1/4-inch-12 thread size
- Right-hand thread direction
- Minimum tube inside diameter of 1-1/4 inches
- Joint not included
- Jam nut not included
Setting up the rod end
A female coupler threads onto the rod end of a tie rod or drag link and accepts a rod end with matching threads. Before fitting, clean the threads on both parts and check them for rust, flattened crests or damage. A coupler that threads on loosely will not hold a load safely.
Setting the length is part of the job. Thread the coupler onto the rod end by hand, then align the joint so the link sits straight at ride height. Tighten the jam nut only after the alignment is correct, since turning the coupler later changes the setup.
Use a thread-locking compound only if the coupler and jam nut are designed for it, and keep threads clean of debris.
- Clean threads on the coupler and rod end
- Set link length before tightening the jam nut
- Check thread engagement after the first drive
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RM12050 |
| Thread size | 1-1/4 inches-12 |
| Thread direction | Right hand |
| Minimum tube inside diameter | 1-1/4 inches |
| Jam nut | Not included |
| Joint | Not included |
Vehicle fitment
No vehicle is named. Fit depends on the tube inside diameter and the thread of the rod end, not on a model.
Confirm the tube size and thread pitch on your rod end before ordering.
Installation notes
Because the jam nut is not included, buy one that matches the 1-1/4-inch-12 thread before installing the coupler.








