Overview
The Artec Crossover Steering Kit, part number SK1401 (A/ISK1401), is a build-it-yourself steering kit with 7/8 inch rod ends. It makes a drag link up to 54 inches long and a tie rod up to 59 inches long, and it is sold as universal fit.
The builder cuts the tubing and sets the final lengths. The kit includes the rod ends, tube adapters, jam nuts, high misalignment spacers and two lengths of DOM tubing.
Key features
- Builds a drag link up to 54 inches long and a tie rod up to 59 inches long
- 7/8 inch rod ends
- Requires the customer to build and cut as needed
- Includes all necessary hardware
- Right hand and left hand rod ends, tube adapters and jam nuts
- High misalignment spacers for the drag link
- 1026 DOM tubing for the drag link and the tie rod
- Universal fit, with the builder setting the final lengths
Fabrication considerations
A fabricated steering link is only as good as its geometry, so the lengths should be set with the wheels straight and the suspension at ride height. Rod ends should be threaded into the tubing with enough engagement, and the jam nuts tightened once the length is correct. Clearance through full lock should be verified before the vehicle is driven.
Steel tubing left bare can rust, so it should be coated or painted after cutting. Keep rod ends clean and lubricated where the design allows, and inspect the joints and jam nuts regularly. Steering components wear faster on rough terrain, so inspection after each trail trip is worth the time.
- Set lengths with wheels straight at ride height
- Verify steering travel through full lock
- Coat cut tubing ends to slow rust
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | SK1401 |
| Alternate part number | A/ISK1401 |
| UPC | 816791023254 |
| Product type | Crossover steering kit |
| Maximum drag link length | 54 inches |
| Maximum tie rod length | 59 inches |
| Rod ends | 7/8 inch |
| Bore | 7/8 inch |
| Tubing | 1.5 inch OD, .250 wall, 1026 DOM |
| Tube lengths included | 48 inches (drag link), 53 inches (tie rod) |
| Fitment listing | Universal fit |
Vehicle fitment
This is a universal fit fabrication kit, cut to length by the builder, so the vehicles it suits depend on the build. Check the axle and steering layout before cutting tubing.
No axle, steering geometry or vehicle information is given. Confirm that the 7/8 inch rod ends and the lengths suit your build before purchasing.
Installation notes
Steering is safety-critical, so the kit should be built and installed by an experienced fabricator or professional. Cut the tubing to the lengths the vehicle needs and follow the recommended thread engagement.
Tighten all jam nuts and fasteners to specification, check steering travel and clearance through full lock, and re-check everything after the first miles of driving. Have the alignment checked afterwards.
What’s included
- 1 right hand and 1 left hand 7/8 x 3/4 bore rod end for the tie rod
- 1 right hand and 1 left hand 7/8 x 7/8 bore rod end for the drag link
- 2 right hand and 2 left hand 7/8 x 14 tpi wrench flat tube adapters for 1.5 inch OD tubing with a .250 wall
- 2 right hand and 2 left hand 7/8 x 14 tpi jam nuts
- 4 high misalignment spacers, 7/8 x 3/4 bore, for the drag link
- 1 length of 1.5 inch OD x .250 wall 1026 DOM tubing, 48 inches long, for the drag link
- 1 length of 1.5 inch OD x .250 wall 1026 DOM tubing, 53 inches long, for the tie rod









